Amana D7824703 installation instructions Parts, Safety Instructions, Before Connecting Ice Maker

IC8 Top and Bottom Freezer Refrigerator Ice Maker Kit Installation and Operating Instructions

Parts

Use listed part numbers only when ordering replacement parts. Part number are not used in installation instructions.

7 6

	5
8	10
9
	4

13

3

1

112

12

Introduction

!Recognize this symbol as a safety precaution.

Read entire manual before installing kit. All necessary tools and materials must be available prior to installation. Verify all listed parts are included in kit. If parts are missing, contact source from whom kit was purchased.

•Mechanical experience is required to install kit.

•If unable to solve a problem during installation, contact an authorized Amana technician. Locate a Factory Service Center or independent authorized technician by calling 1-800-628-5782inside U.S.A. and 1-319-622- 5511 outside U.S.A. Service is at owner’s expense.

Safety Instructions

!WARNING

To avoid electrical shock which can cause severe personal injury or death, unplug power cord or open household circuit breaker to refrigerator before installing kit. After installing kit, reconnect power.

Item	Description	Part number
1	Ice maker	D7824703
2	Ice maker cover	10519801
3	5/8" long sheet metal screw (to	M0211118
	secure ice maker)
4	Stainless steel clip	B5720302
5	Ice maker wire harness clamp	10526701
6	Ice maker wire harness	D7813004
7	Ice maker arm	10884401
8	Button plug	M0311301
9	Oblong plug	A3124301
10	Thermal fuse clip (attached to	10319801
	ice maker)
11	Plastic clips (4)	M0104106
12	Ice storage bucket	10476201
13	Compression nut and sleeve	10244904
N/S	Warning level (attached to side	A3036901
	of ice maker)
N/S	Diagnostic label (inside ice	10834701
	maker cover)
N/S	Installation Instructions	10527033

N/S= Not shown

!Caution

To avoid property damage, observe the following:

•Confirm water pressure to water valve is at least 20 pounds per square inch.

•Start nuts by hand to avoid cross threading. Finish tightening nuts using a wrench. Do not overtighten.

•Check carefully for water leaks prior to returning refrigerator to normal location and 24 hours after connection.

Before Connecting Ice Maker

Important

•Before connecting ice maker, contact a plumber to connect copper tubing for refrigerator water supply to household plumbing in compliance with local codes and ordinances.

Use 1/4" (6 mm) flexible copper tubing. Length of copper tubing must reach from water supply connection plus an additional 8' (2.5 m) for service loop behind refrigerator.

Tubing should be soft instead of rigid and ends should be free of burrs.

Copper tubing route must be above 35°F (2°C) to prevent water line from freezing.