Insert screws
5/8" sheet metal screws here
Clips
Install Ice Maker
1.Remove any shelves that may obstruct installation of ice maker module.
Models with ice service rack
Slide ice service rack toward front of freezer until screws are in middle of mounting holes. Gently pull ice service rack away from freezer. Remove screws using a 1/4" hex nut driver. Insert provided plugs into screw holes.
Bottom Freezer models Remove freezer shelf and basket.
Top Freezer models Remove freezer shelf.
2.Install hole plugs to properly position for ice maker.
Models with half-width freezer shelves
Push 2 oblong plugs provided, into 2 lowest shelf slots on left side.
Models with full freezer shelves
Push 1 oblong plug provided, into lowest shelf slot on each side.
3.Remove ice maker from shipping carton and discard packing material.
Important
Ice maker is shipped with arm down. This is correct position for ice production. Do not force arm up or down.
4.Slip stainless steel clip over rear wall of ice maker water cup.
Stainless steel clip
Water cup
5.Remove and discard 3 button plugs from left freezer wall using flat blade screwdriver with blade covered with masking tape.
6.Start 5/8" sheet metal screw in top front hole, and top rear hole in left wall. Leave heads out approximately 3/8".
Important
Ice maker can be installed one way only. Do not drill additional holes.
7.Hold ice maker in position. Verify two outside electrical flats line up with flats in receptacle on freezer back wall. Insert wire harness plug into receptacle on rear wall until locking fingers on plug snap into place. Slip ice maker hanger over sheet metal screw.
Wire harness | Wire harness | |
receptacle | ||
plug |
Sheet metal screw
Ice maker hanger
| or | |
Wire harness | Wire harness | |
plug | ||
receptacle | ||
Sheet metal | ||
| ||
screw |
| |
Ice maker |
| |
hanger |
|
8.Ease ice maker water cup toward end of water fill tube. Water fill tube fits under stainless steel clip. Water fill tube must not be kinked. Water fill tube elbow should extend 3/8" into ice maker water cup and must be secured under stainless steel clip.
Stainless | Water fill tube |
steel clip | |
Water |
|
cup |
|
9.Install remaining 5/8" long sheet metal screw to secure ice maker. Tighten all 3 screws.
10.Reinstall freezer shelf and and any baskets.
11.Position ice storage bucket on freezer shelf under ice maker.