A sturdy floor to support the total dryer weight of 200 lbs (90.7 kg). The combined weight of a companion appliance should also be considered.

A level floor with a maximum slope of 1 in. (2.5 cm) under entire dryer. If slope is greater than 1 in. (2.5 cm), install Extended Dryer Feet Kit, Part Number 279810. Clothes may not tumble properly and automatic sensor cycles may not operate correctly if dryer is not level.

For a garage installation, you will need to place the dryer at least 18 in. (46 cm) above the floor. If using a pedestal, you will need an additional 6 in. (15.24 cm).

Do not operate your dryer at temperatures below 45ºF (7ºC). At lower temperatures, the dryer might not shut off at the end of an automatic cycle. This can result in longer drying times.

The dryer must not be installed or stored in an area where it will be exposed to water and/or weather.

Check code requirements. Some codes limit, or do not permit, installation of the dryer in garages, closets, mobile homes, or sleeping quarters. Contact your local building inspector.

Installation clearances

The location must be large enough to fully open the dryer

 

door.

Additional spacing should be considered for ease of

 

installation and servicing.

Additional clearances might be required for wall, door and

Minimum installation spacing for custom undercounter installation

The dimensions shown are for the minimum spacing allowed.

Custom undercounter installation - Dryer only

Minimum installation spacing for recessed or closet installation, with or without a pedestal

The dimensions shown are for the minimum spacing allowed.

For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilation openings are acceptable.

Closet installation - Dryer only

 

floor moldings.

Additional spacing of 1 in. (2.5 cm) on all sides of the dryer is

 

recommended to reduce noise transfer.

Companion appliance spacing should also be considered.

Dryer Dimensions

½

 

 

"

 

 

"

"

½"

"

 

1

 

"

in.

in.

"

2

1.Side view- closet or confined area

2.Closet door with vents

Recessed or closet installation - Dryer on pedestal

* ½

*Most installations require a minimum 5½ in. (14 cm) clearance behind the dryer for the exhaust vent with elbow. See “Venting Requirements.”

1

½

2

1.Recessed area

2.Side view - closet or confined area

6

Page 6
Image 6
Amana YKEHS01P manual Installation clearances, Dryer Dimensions, Custom undercounter installation Dryer only