WATER VALV
O Remove shipping plug from water hflet valve,
OInstall a 90 ° elbow (3/8" N,P.T) fitting h, to the water valve using Teflon r'_ tape or pipe thread compound. The opposite end of"the fitth*g should fit
IMPORTANT: DO NOT connect a sweat type fitting directly to the water valve as the required beat will damage the water inlet valve. Do not solder within 6" (15.2 era) from the water valve.
CAUTION:With the door open, dishwasher may tip forward if it is not se<ure in position to cabinet,
:, RAIR ROSEPREPARATION
_}
_,:_:..
Diagram A
Dishwasher drain must bave a 32" (812) loop. Drain hose may be clipped to either skle of the disbwasber (see diagram A) It is preferred that the drain bose be routed high enough to provide the 32" loop. If a loop eammt be put in the installation, an air gap (not included) may be used.
IMPORTANT: Routing of the drain hose is most important to insure satisfactory operation. It is not recommended to extend drain line beyond 7' (2.1 m). Howevei; sbou[d this be necessary, it must always be attached to a hne of larger inside diametel: An accessory drain hose extension kit (#904204) is available through your autborized dealel: DONOT route drain hose across the top of the tub, all bends must be gradual to prevent kinking or co!lapsing of the hose,
IMPORTANT: Drain bose may change position even after installation, To insure proper operation, secure hose
to either side of cabinet wail, or to rob with bose dip (provided) to assure a 32" loop. Make certain there are no kinks.
| IMPORTANT: | I)o not | attach | the drain | bose to any connection | smaller than 1/2" | I.D. |
|
(Shle view of dishwasher) | IMPORTANT: | Never | cut the | corrugated | portion of drain hose. | All connections |
|
|
| must be made | to rubber | portions of drain | hose. If cutting of drain | bose is required, | .............. \ | ||
| do not cut past the 5/8" line. |
|
|
| Mtflti | flex Drain Hose | ||
|
|
|
|
|
|
|
DRAN
A 5/8" (1.6 era) LD (Inside Diameter) x 7 ft. (2.1 m) corrugated drain hose is positioned on side of dishwasher tub.
Drain hose | connection | can | be located on either | Mde of compartment. | Elevate | drain hose | ||
to a height of at least | 32" | (81 era) above | the | f'loox: If drain connection is to be made | ||||
below the | floor; bose sbouM be left in the | looped position. It may | be necessary | to extend | ||||
drain bose | for connection. | DONOT reduce | the | drain hose to less | than | 1/2" (1.3 cm) I.D. |
(Inside Diameter).
+d+++........
{ ' smoRIRG TRtDISRWASRtR
_1_ With the door latched, position dishwasher h* front of cabinet opening. Insert drain bose through the opening provided_
Guide disbwasher into the cabinet, puHh_gdrah_ hose through opening as you proceed. Make sure drain bose is not kinked.