3UHSDUHAttention/RFDWLRQ Installer
3UHSDUH• Make sureUHIULJHUDWRUcutout floor is levelIRU. If theGHOLYHU\floor is not level it is necessary to shim the rear wheels onto a piece of plywood or other shim material so refrigerator is level.
Amana cannot be responsible for improper installation.
Shim refrigerator wheels as needed
!WARNING
To avoid electrical shock which can cause severe personal injury or death, disconnect power outlet from main power supply before installing or servicing refrigerator.
|
|
|
|
|
|
Some installations may require door removal to |
| ! CAUTION |
|
| |
get the refrigerator into the home. |
|
|
|
| |
| To avoid electrical shock which |
| |||
1. | Remove toe grille. |
|
| ||
| can cause severe personal |
| |||
2. | Remove top hinge cover and top hinge. |
| injury or death, green ground wire | B | |
| Dispensing and Electronic Models |
| must remain attached to hinge. | ||
|
|
|
|
|
•Disconnect wire connectors.
Loosen the water tube clamp (A). Loosen the
water tube union nut (B). Pull the water tube away from the union nut and through the tube clamp.
• Unplug electrical connector from voltage box (C).
3. Remove doors. | A |
•Remove top hinges.
• Remove doors from bottom hinge.
4. Attach
• Remove bottom hinge.
refrigerator to appliance cart.
Top left
Bottom | Bottom | |
right | ||
left | ||
|
,QVWDOOUHIULJHUDWRU
!CAUTION
To avoid floor and wall damage protect walls and soft vinyl or other flooring with masonite or other protective material when moving the refrigerator.
1.Reinstall doors by performing section 2 in reverse order.
2.Connect ice maker water supply line. (Refer to Owner’s Manual)
. Plug power cord into electrical receptacle.
4.Move refrigerator into final location.
5.Once refrigerator is located and stable, level refrigerator by adjusting front, and rear (some models) cabinet leveling adjustment screws.
6.Reconnect power from power source to electrical receptacle.
7.Align doors.
•To align tops of doors loosen the 2 bottom right side hinge screws. Turn cam to raise or lower refrigerator door (Some models). (Refer to label inside refrigerator compartment on bottom mullion.)
•Tighten the 2 hinge screws.
3UHSDUH8. Replace toeUHIULJHUDWRUgrille. IRUXVH
1.Remove all interior packaging material.
2.Clean interior and exterior of refrigerator.
3.Instruct consumer on controls and features.
| "P" clamp |
|
| Brass nut |
|
Copper |
| Loosen hinge screws |
tubing | Brass sleeve | |
| Water valve | 2 turns counterclockwise |
|
| |
| inlet connection |
|
| cabinet leveling |
ALIGN | adjustment screw |
Door alignment
adjustment cam (some models)
4. Verify power to refrigerator is connected.
Part No. 12123312 | Printed in U.S.A. |