ELECTRONIC OVEN CONTROLS
A BCD E
I | H | G | F |
A. Oven light |
| F. Temperature/time | |
B. Clock |
| G. Broil |
|
C. Oven display |
| H. Bake |
|
D. Start/control lock | I. Timer |
| |
E. Cancel/off |
|
|
|
Display
When power is first supplied to the appliance, a flashing time will appear on the display. Press CANCEL/OFF to clear the display.
If a flashing time appears at any other time, a power failure has occurred. Press CANCEL/OFF and reset the clock if needed.
When the oven is not in use, the display shows the time of day.
RangeLights
Oven Light
While the oven door is closed, press OVEN LIGHT to turn the light on and off. The oven light will come on when the oven door is opened.
When performing a timed cook function, the display will show | Tones |
either hours and minutes, or minutes and seconds. | Tones are audible signals, indicating the following: |
|
Start
The Start pad begins any oven function, except kitchen timer. If the Start pad is not pressed within 5 seconds after pressing a function pad, the “START?” or “PUSH?” indicator light will appear on the display (on some models).
If the Start pad is not pressed within 1 minute after pressing a function pad, the oven display will return to the time of day mode and the programmed function will be canceled.
Cancel/Off
The Cancel/Off pad stops any function except the Clock, Timer, and Control Lock.
Clock
To Set:
Before setting, make sure the oven and Timer are off.
1.Press CLOCK.
2.Press the TEMP/HOUR “up” or “down” arrow pads to set the time of day.
3.Press CLOCK or START.
On some models, clock display can be turned off or on by pushing and holding CLOCK.
Basic Functions
One tone
■Valid pad press
■Oven is preheating (long tone)
■Function has been entered
■Reminder (on some models), repeating each minute after the
Three tones
■Invalid pad press
Four tones
■End of cycle
Reminder Tones: The audible tones at the end of the Timer may be set to beep once or continue to beep. Press and hold TIMER for 5 seconds to enter Options mode. “Opt” will appear on the display. Use TEMP/HOUR to cycle through the options until you reach “b” or “b1” (depending on your model). Cycle on and off using TIMER. Press CANCEL to exit the mode.
Fahrenheit andCelsius
The temperature is preset at Fahrenheit, but can be changed to Celsius.
To change: Press and hold BROIL for 5 seconds. A tone will sound and “°C” or “°F” will appear on the display. Repeat to change back to Fahrenheit.
To exit mode, press CANCEL/OFF.
7
