4
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
The parts supplied are in the washer drum.
Tools needed for connecting the water inlet hoses
Pliers (that open to 19/16" [39.5 mm])
Flashlight (optional)
Tools needed for installation
Open end wrenches 17 mm and 13 mm
Level
Wood block
Ruler or measuring tape
NOTE: Replace inlet hoses after 5 years of use to reduce the risk
of hose failure. Record hose installation or replacement dates for
future reference.
Parts supplied:
Alternate Parts
Your installation may require additional parts. If you are interested
in purchasing one of the items listed here, call the toll-free
number on the cover or in the “Assistance or Service” section.
Options
Pedestal
You have the option of purchasing pedestals of different heights
separately for this washer. You may select a 10" (254 mm) or a
15.5" (394 mm) pedestal. These pedestals will add to the total
height of the washer for a total height of approximately
48" (1219 mm) or 53.5" (1359 mm).
To order, call the dealer from whom you purchased your washer
or refer to the “Assistance or Service” section.
Stack Kit
Are you planning to stack your washer and dryer? To do so you
will need to purchase a Stack Kit.
To order, call the dealer from whom you purchased your dryer
or refer to the “Assistance or Service” section. Ask for Part
Number 8541503.
Location Requirements
Selecting the proper location for your washer improves
performance and minimizes noise and possible washer “walk.”
Your washer can be installed under a custom counter, or in a
basement, laundry room, closet, or recessed area. See “Drain
System.”
Companion appliance location requirements should also be
considered. Proper installation is your responsibility.
You will need
A water heater set to deliver 120°F (49°C) water to the
washer.
A grounded electrical outlet located within 6 ft (1.8 m) of
where the power cord is attached to the back of the washer.
See “Electrical Requirements.”
Hot and cold water faucets located within 4 ft (1.2m)
of the hot and cold water ll valves, and water pressure
of 20-100psi (137.9-689.6 kPa).
A. Drain hose form
B. Inlet hose (2)
C. Inlet hose washer (4)
D. Transport bolt hole plug (4)
E. Beaded strap
If You Have You Will Need to Buy
Laundry tub or
standpipe taller
than 96" (2.4 m)
Sump pump system (if not already
available)
Overhead sewer Standard 20 gal. (76 L), 30" (762 mm) tall
drain tub or utility sink and sump pump
(available from local plumbing suppliers)
Floor drain Siphon break, Part Number285834;
additional drain hose
Part Number8318155; and
connector kit, Part Number285835
Drain hose too
short 4 ft (1.2 m) drain hose extension kit,
Part Number285863
Water faucets
beyond reach of ll
hoses
2 longer water ll hoses:
6 ft (1.8 m) Part Number76314,
10 ft (3.0m) Part Number350008
A B
C
D E
A. 10" (254 mm) pedestal
B. 15.5" (394 mm) pedestal
Pedestal
Height
Color Part Number
10" (254 mm)White WHP1000SQ
15.5" (394 mm)White XHP1550VW
A B