Installation
Slide Bar
Connector
Window Kit Installation
Installation
Mounting the Exhaust Pipe
•The supplied Exhaust Hose can be extended from 1 foot to 5 feet
for mounting. It is recommended that
you use the shortest possible length of Hose.
•Take care to prevent any kink or bend in the middle of the Exhaust Hose, as this will trap hot exhaust air, which will radiate back into the room.
In order for this unit to function properly, it must be vented to the outside.
Fitting the Exhaust Hose through the window is easy. Please see below.
1.Extend Hose at least 6" and insert it into back of the unit, tightening into place by turning it clockwise.
2.Attach Slide Bar Connector, (Round Connector) to the other end of the Hose by extending hose at least 6". Then tighten Hose by turning the (Round Connector) clockwise.
3.Place Adjustable Slide Bar in the window and expand so it fits tightly.
4.Lower the window.
5.Make sure the Hose has no kinks.
Slide Bar has 3 sections which allows installation in windows up to 48" in width.
Round
Connector
WARNING!
The length of the Exhaust Pipe is specially designed according to the specification of this product.
Do not replace or extend it with your own hose as this could cause the unit to malfunction.
Cleaning the Filter
Wall Connection
Use a vacuum cleaner or tap the filter lightly to remove loose dust and dirt from the filters and then rinse them thoroughly under running water (no hotter than 104ºF)
1.Make a hole (5.1" in diameter) in the wall.
2.Insert the Round Connector (part #13) into the hole and hold in place by using 4 small screws (not supplied).
3.Extend one end of the Exhaust Pipe (part #11) and screw into the Round Connector by turning clockwise.
4.Extend other end of exhaust pipe and screw in Adaptor (part #10) by turning clockwise.
5.Push Adaptor to fit firmly over the opening on the back of the unit.
**When not in use, cover the Round Connector and hole with Cap (part #14).
Dry thoroughly before replacing.
Notice! Never operate the unit without the filters.
6 | 7 |
