Amcor 000EH Operation, Parts, Control Panel, Accessories10, FrontBack, Adjustable Slide Bar

Operation

Control Panel	Cool	Set Temp.	Low Fan	Timer
Fan Only		Room	High	Not available
		Auto Temp.	Fan	on all units Power

Mode:

AC or Fan

Temp. Up

Temp. Down	Timer
	On / Off

Parts

FrontBack

1

2

3

Fan Speed:

High / Low

Setting Mode/Function

Not available on all units

4

Press the MODE button to select the required working mode:Automatic, Cooling, Fan or Heating (Heating is only available for ALD-12,000EH).The green indicator illustrating your selected mode lights up. It is recommended to select Cooling or Heating mode and set your desired temperature, as the Auto mode has a preset temperature (please see below) that cannot be changed.

The indicators of the functions in progress come on at the same time, e.g. Cool and Lo = Cooling mode with Low fan speed.

Auto Mode

When this mode is selected, the unit is preset to the following temperature settings and unit will only start to:

•Cool when room temperature is higher than 75ºF

•Heat when room temperature is lower than 68ºF (ALD-12,000EH only)

If room temperature is between 68ºF and 75ºF, unit will stay in Fan mode. Again, when in Auto Mode, the temperature settings cannot be changed.

Setting the Temperature in Cooling or Heating Mode

The display window’s default is to display the ambient room temperature. The green indicator light under RT is on. (RT = Room Temperature)

To set your desired temperature, press the Temperature up or down buttons (ranging from 62ºF to 90ºF). Each press will increase or decrease your set temperature by 1ºF. When pressing the temperature up or down buttons, the window will change to display your set temperature.At this time, the green indicator will light under ST (Set Temperature). Once the temperature up or down buttons is released, the window will return to displaying the ambient temperature after a second.

Note: When unit is in the following modes: Auto, Cool, or Heat - the compressor will cool/heat the room to reach the set temperature. Once the ambient temperature has reached the set temperature, the compressor will stop and unit will run in Fan mode. To conserve energy, the compressor will not start immediately after a couple degrees increase or decrease, but will wait for a 5ºF allowance. For example:

In Cooling Mode with a set temperature of 70ºF

When compressor first stops after reaching 70ºF, unit will auto-switch to Fan.

Compressor will start cooling again when ambient temperature increases to 75ºF or above.

In Heating Mode with a set temperature of 72ºF

When compressor first stops after reaching 72ºF, unit will auto-switch to Fan. Compressor will start heating again when ambient temperature drops to 67ºF or below.

In Auto Mode (with preset temperature of 68ºF for heat and 75ºF for cool)

Compressor will start cooling again when ambient temperature reaches above 80ºF or will start heating when ambient temperature drops below 63ºF.

1.	Control Panel	5.	Air Filter
2.	Cooling Air Outlet	6.	Air Inlet
3.	Handle	7.	Exhaust Air Outlet
4.	Castors	8.	Cord Hanger
		9.	Water Stopper (Rubber Plug Inside)

Accessories10

10. Adaptor - for insertion over the

hose and into the back of the12 air conditioner

11. Exhaust Hose

12. Adjustable Slide Bar 11

13. Round Connector

13

14.Cap for Round Connector

15.Remote Control

(Electronic control models only)	14
	15

8 5