Mounting
Wall Mounting
4 fixing brackets, 4 screws, and 4 plastic wall plugs are included so the heater may be mounted onto a wall.
If the heater will be mounted to the wall, do not attach the feet.
Chose the mounting location carefully. It must not be in front of, or below, a power outlet. It must not be below a shelf, curtains or any other obstruction. Also refer to the safety instructions.
After deciding on the location of the heater, it is necessary to drill 2 fixing holes 0.31" (8mm) by 1.7" (43mm) deep at 16.5" (419.1mm) apart on a horizontal line at a minimum of 15.75" (400.05mm) from the floor [shown (a)].
750W OFF
1500W750W OFF
OFF
*
(a)Minimum height of 15.75" (400.05mm) from the floor.
Allowance must be made for any floor coverings, carpet, etc., and if any base board
molding is present, the fixing holes must be a minimum of 15.75" above the top edge of the molding.
Using the plastic plugs and fixing screws provided, attach two of the fixing brackets to the wall. The other pair of fixing brackets must be attached to the base of the heater using the feet retaining screws, so that the brackets project out at the rear of the heater and space the bottom edge away from the wall.
If required, these brackets may also be secured to the wall using the remaining fixing screws and plastic wall plugs. If this option is chosen, it is suggested that the heater be hung on the upper brackets and the hole positions for the lower brackets are then marked on the wall, prior to drilling the holes for attachment purposes.
Maintenance
Cleaning the Heater
•Always
•Clean the outside of the heater by wiping with a damp cloth and buff with a dry cloth.
•Do not use any detergents or abrasives and do not allow any water to enter the heater.
Storing the Heater
When the heater is not used for long periods of time, it should be protected from dust and stored in a clean dry place.
5
