Troubleshooting
START-UP
Compressor does not start, even though the desired temperature is lower than the temperature in the room.
1.Check the wall socket by plugging in any type of electrical device, and make sure that the on/off button is pressed.
2.Press the TEST button and check that the two red and green indicator lights light up. (In the standby status).
3.If the compressor still does not start after steps 2 and 3, contact your dealer.
Compressor Does Not Stop.
1.Place your hand on the condenser (metal screen at the back of your cabinet) to check its temperature Contact your dealer if cold.
2.If the condenser is hot, set the cold temperature as high as possible (as far as it will go clockwise) and make sure that the cold circuit operation indicator goes off. lf the compressor does not stop, unplug the cabinet and contact your dealer.
DURING OPERATION
Digital Tube display indicates a temperature below the temperature you set.
1.Check the temperature
2.Check that the red hot circuit operation indicator light is on.
3.Press the TEST button, and check that the two red and green indicator lights on the right side of the panel are on. lf either step 2 or 3 is incorrect contact your dealer.
Digital Tube display indicates a temperature above the temperature you set.
1.Check the temperature
2.Check that the green cold circuit operation indicator light is on.
3.Press the TEST button, and check that the two red and green indicator lights on the right side of the panel are on. lf either step 2 or 3 is incorrect contact your dealer.
Contact your dealer, if after adjusting
NOTE: The refrigeration unit must only be serviced by a refrigeration technician, who must check the circuit for leaks before putting back into service.
Any servicing of the electrical circuit must only be performed by an electrician.
Whatever the case, if your cabinet does not seem to be operating normally, unplug it and call your dealer.
14
