American Acoustic Development C -11 manual Equalizer on/off, bandEqualizer, High Level Inputs L&R

pressure wave. You can use this position if you are unable to get a good integration between the subwoofer and main speakers.

Equalizer on/off

At “off” position, the amplifier will function normally without the effect of the 5-band equalizer.

5-band Equalizer

Please refer to “Setting up EQ for the Room”

High Level Inputs L&R

These inputs should be connected to the left and right speaker terminals of your amplifier/receiver, if you intend to connect the subwoofer using this option instead of the low-level RCA input connections.

8High Level Output L&R

You could connect your main speakers from the subwoofer amplifier instead of the main amplifier/receiver. Use this option if you are connecting the subwoofer up via the High Level Input.

CAUTION! Do not use both low level and high level connection methods simultaneously. This may cause damage to the subwoofer and your amplifier/receiver.

Low level Input & Output

Connect this to the pre-amp output of your amplifier/receiver. If you do not have a pre-amp output or a power amplifier input, you can connect up the subwoofer using the Low Level Input/Output utilizing a tape input/output amplifier/receiver. Connect the tape output to the Low Level Input on the subwoofer, then connect the tape input to the Low Level Output on the Subwoofer. To switch the subwoofer into the circuit, switch the tape monitor input on your amplifier/receiver.

Use this in conjunction with your receiver/amplifier. Connect this output to the power amplifier input of your amplifier/receiver.

Power input socket and Fuse

For continued protection, replace only with same type fuse. (A spare fuse is enclosed for replacement.)

1-4