Motherboard BIOS and Setup Utility
53
3.12.8.4 Video Palette Snoop
Controls the ability of a primary PCI graphics controller to share a common palette with an ISA
add-in video card. The options are Enabled and Disabled. The default is Disabled.
3.12.8.5 Latency Timer (PCI Clocks)
Sets the length of time an agent on the PCI bus can hold the bus when another agent has requested
the bus. Valid numbers are between 0 and 256. The default is 66.
3.12.8.6 PCI Burst
Controls the support for PCI to memory burst mode data transfers. The options are Enabled and
Disabled. The default is Enabled.
3.12.8.7 DIMM Type Detection
Reports the type of memory found in each of the two memory banks. There are no options.
3.12.9 Power Management Configuration Subscreen
This section describes the options available on the Power Management Subscreen.
3.12.9.1 Advanced Power Management
Enables or disables the Advanced Power Management (APM) support in your system’s BIOS. The
options are Enabled and Disabled. The default is Enabled. Power Management will only work
with APM-capable operating systems to manage power consumption in your system. If Advanced
Power Management is set to Disabled, none of the fields in the Advanced Power Management
subscreen will be visible.
3.12.9.2 IDE Drive Power Down
Sets any IDE drives to spin down when the system goes into power managed mode. The options
are Enabled and Disabled. The default is Enabled.
3.12.9.3 Inactivity Timer
Sets how long the system must be inactive before it enters power managed mode. Enter the
number of minutes. The range is 0 to 255 minutes. The default is 10 minutes.
3.12.9.4 VESA Video Power Down
Sets the command issued to your graphics card when the system goes into power managed mode.
The options are Disabled, Standby, Suspend, and Sleep. The default is Sleep.
3.12.9.5 Hot Key
Sets the hot key that, when pressed while holding down the <Ctrl> and <Alt> keys, causes the
system to enter power managed mode. All alphabetic keys are valid.