©American Audio® - www.AmericanAudio.us - Flex 100MP3 Instruction Manual Page 22
BASIC OPERATIONS (CONT.)
15. RECALL FLASH mEmORY: The Flex 100MP3 can store all your user programmed cue points in to memory.
These cue points may be recalled at any time, even when a disc has been
removed and reloaded at a later time. To recall the memory on a specific disc; 1)
Be sure a CD is not loaded in to the drive. 2) Press the memory Button (17)
down until the red memory LED turns on. 3) Load the CD. "RECALL" will appear
in the lcd (28) while the memory is being installed and the red memory But-
ton (17) LED will turn off.
17. FIRmWARE VERSION DISPLAY: You may display the units firmware version. Firmware is the units internal programming code. To view the firm-
ware version; While main power is turned off, press the memory Button (17) and the 1st Bank Button
(13) simultaneously and turn the main power on. To exit the firmware version press the track knoB (26).
16. CLEAR ALL mEmORY: You may clear the system memory at any time. This will erase all your programmed memory and restore the
unit to it's default settings. To clear the memory; While main power is turned off, press the memory Button
(17) and the 2nd Bank Button (13) simultaneously and turn the main power on. The lcd (28) will flash "Clear
All" and default memory will be restored.
14. SYSTEm mEmORY: The Flex 100MP3 comes with an incredible memory system. The unit can memo-
rize all cue points used on a particular disc. To store all your setting for a CD,
press and hold down the memory Button (17) for at least three seconds.
When the memory has been stored properly the memory led will turn off.
Figure 25
Figure 26