American Audio CDS-1 EXITING A LOOP, LOOP INDICATORS

BASIC OPERATIONS (CONT.)
American Audio® • CDS-1™ INSTRUCTION MANUAL • PAGE 18
EXITING A LOOP - To exit a LOOP when a loop is active, press the OUT
BUTTON (11) (Figure 20). The IN BUTTON (10) and OUT BUTTON (11) LEDs
will remain on, but will stop flashing. Music playback will resume normal
play. The IN BUTTON (10) and OUT BUTTON (11) LEDs will remain on to
remind you that a loop is stored in memory.
3) Press the OUT BUTTON (11) to set the ending point for your LOOP
(Figure 19). The IN BUTTON LED (9) and OUT BUTTON LED (16) will begin
to flash indicating the LOOP mode has been activated.
LOOP INDICATORS - During a loop, the IN BUTTON LED (9) and OUT
BUTTON LED (16) will begin to flash indicating the LOOP mode has been
activated.
A loop will remain in memory until a new loop is made or the unit has been
powered down. When a loop remain in memory but has been deactivated
(exited) the IN BUTTON LED (9) and OUT BUTTON LED (16) will glow solid
red.
2) Press the IN BUTTON (6). This will set a loops starting point. The
IN BUTTON (6) LED will briefly indicating a starting point has been
set.
Figure 18
Figure 19
Figure 20