American Audio CK 800Mp3 GENERAL FUNCTIONS AND CONTROLS (Cont.) mIxER

applied to a channel signal.

CHANNEL BASS CONTROL - This knob is

used to adjust the low frequency levels of a chan-

nel allowing for a maximum bass gain of +12dB

or maximum signal decrease of -30dB. Turning

the knob in a counter-clockwise direction will

decrease the amount of bass applied to a chan-

nel signal, turning the knob in a clockwise direc-

tion will increase the amount of bass applied to a

channel signal.

21. mASTER VOLUmE LEVEL INDICATORS -

The dual MASTER LEVEL LED indicators are used

to detail the master output level. The meters will

detail the output level of both the left and right

channels.

22. CHANNEL FADER - These faders are used to

control the output signal of any source assigned

to its particular channel.

23. RELAY BUTTON - This button activates the

FLIP-FLOP™ function.

24. Q-START ON/OFF SWITCH - With this func-

tion you can use the crossfader to start and stop

the CD play. The on/oFF “Q” START switch acti-

vates the fader “Q” start feature. When the fader

“Q” start feature is activated sliding the croSS-

fader (25) from left to right will play or cue the

CD player connected.

Example: Be sure the Fader “Q” Start

feature is activated on both channels.

Slide the crossfader to the channel one

position (full left) and begin playback on

CD drive one. Slide the crossfader to the

channel position (far right). This will im-

mediately trigger the play function on CD

drive two and return CD drive one to cue

mode. To return to normal fader operation

turn the Fader “Q” Start on/oFF SWITCH

to the OFF position.

25. REPLACEABLE CROSSFADER - This fader

is used to blend the output signals of channels

one and two together. When the fader is in the full

left position (channel 1), the output signal of chan-

nel one will be controlled by the master volume

level. The same fundamentals will apply for chan-

nel two. Sliding the fader from one position to

another will vary the output signals of channels

one and two respectively. When the crossfader

is set in the center position, the output signals of

both the channels one and channels two will be

even.

26. CUE mIx - This knob is used send a chan-

nels incoming signal to the headphones. Turn

the knob counter-clockwise to monitor Channel

1, and clockwise to monitor Channel 2. The cue

level is adjusted by the cue leVel Volume

knoB (27). Be sure the cue level is set to mini-

mum before putting a pair of headphones on.

27. CUE LEVEL VOLUmE KNOB - This knob is

used to adjusts the headphone volume output

level. Turn the knob in a clockwise direction to

increase the headphone volume.

28. mASTER VOLUmE CONTROL - This rotary

knob is used to control the master output level

(volume). To avoid distorted output try to main-

tain an average output signal level +4 dB. Be sure

this volume control is always set to zero before

turning the unit on.

29. mICROPHONE VOLUmE - This knob is used

to regulate the microphone output volume. Turn-

ing the knob in a clockwise direction will increase

the volume level.

GENERAL FUNCTIONS AND CONTROLS (Cont.) mIxER