DV2 USB Controls and Features Cont.
©American Audio® - www.AmericanAudio.us - DV2 USB Instruction Manual Page 8
18. aC COnneCtIOn - This connector is used to supply main power to the unit via the included
detachable power cord. Use only the supplied, polarized AC power cord. This cord is designed to t in
one direction only. Do not attempt to force a cord in if it does not t, be sure the cord is being inserted
properly
19. MaIn POWer SWItCh - This is the main power ON/OFF button. The power switch will glow red
when power is ON. Before main power is applied, be sure you have made all connections to the mixer.
Also be sure your amplier(s) is(are) tuned off. Remember to avoid damaging pops, the mixer should
be powered on rst and turned off last.
20. USB POrt - Use this jack to connet to a computer.
21. PLaYer COntrOL - These jacks are used to control the “Q-Start” function between the mixer
and a compatible American Audio CD Player. Input mini plugs from CD player controller into these
jacks, input CD 1 into jack A and CD 2 into jack B.
22. LIGht COntrOL - This jack provides a preset mono audio signal output. There is no way to
adjust this level, however this level will directly reect the output level of the cHANNEL FADERS (8).
This buffered audio output should only be used for light controllers that can accept an external audio
input. Great for Touch Panels and Chase Controllers.
23. MICrOPhOne jaCk - This jack is used to a connect a microphone to the mixer. Connect you
microphone via 1/4 inch (6.3mm) jack. The signal volume will be controlled by the MIc VOLuME kNOb
(13). The bass and treble levels can also be adjusted by the built-in MIcROPHONE EQ (12).
24. GnD (GrOUnD terMInaL) - Connect each of your turntables ground leads to either of the two
ground terminal. This will reduce the humming and popping noises associated with magnetic phono
cartridges.
32 262728293031
22212018
2425
19 23
25