Quick start: American Audio® would like to thank you for your purchase of this great audio prod-
uct. For those of you that don't have the time to read the entire user manual we have compiled these
quick start instructions. We hope that you will at least read through these instructions to familiarize
yourself with the basics of this mixer. The Q Record is part of American Audio’s continuing evolution
in audio technology. This unit has been built and designed to meet the needs of a typical DJ. We have
attempted to provide you with the most reliable product on the market by using only components con-
structed of the nest material.
Master LeVeL - Use this level to control your main volume output. Try never to send an output of
more than +4dB to your system. Signal at levels higher than this will star t to distort and may cause
damage to your system and speakers. Remember that a distorted signal from your mixer will only be
multiplied throughout your system.
channeL Gain LeVeL - The channel gain levels are not to be used as volume controls. Never use
the channel trim to set the output volume. These controls are used to aid in distortion control. Use
these control to preset your signal level before the crossfader. With your channel faders in the maxi-
mum position, use the channel trim level to set an average output level of about +4dB on you master
level meter.
heaDphones - To avoid damaging your headphones always be sure the headphone volume level
(13) is set to minimum before plugging them in. To avoid sever hearing damage, never put the head-
phone on without making sure the headphone level is turned down.
Main Mic - The main mic connector uses a combo plug that allows you to connect either a 1/4”
unbalanced jack or by a standard 3-pin XLR balanced connector. The main mic also has an indepen-
dent volume control. When feedback occurs when using the mic, try lowering the level this may reduce
the feedback. Always leave the mic level to it’s minimum level when not in use. note: We recommend
that you use a 500-600ohm microphone for the best sound quality.
phono/auX Line LeVeL seLector sWitch - This switch is used to change the selected input
from phono to line and vice versa. The switch selectors are on the rear panel.
Q RECORD QUI Ck STA RT IN STRUCT IONS Q RECORD UNPACkING
Every Q Record has been thoroughly tested and has been shipped in perfect operating condition.
Carefully check the shipping carton for damage that may have occurred during shipping. If the carton
appears to be damaged, carefully inspect your mixer for any damage and be sure all equipment neces-
sary to operate the mixer has arrived intact. In the event damage has been found or parts are missing,
please contact our toll free customer support number for further instructions. Please do not return the
mixer to your dealer without rst contacting American Audio® customer support.
©American Audio® - www.americanaudio.us - Q Record Instruction Manual Page 7
Q RECORD IMPORTANT USB INfORMATION
• Make sure your usB device has only Mp3 files on it. there cannot be any other type of files
on your usB device, no WaV files, photo files, etc...
• only external hard drives* with exter nal power supplies are supported. When using an ex-
ternal hard drive, if you switch the Q record "off" and then back "on" again you will need
to disconnect and then reconnect your external hard drive usB plug. if you do not do this
the Q record will not detect your connected hard drive.
• if you are using a sD card via usB sD card reader, you must remove the usB sD card
reader first to change sD card's. please do not remove the sD card from the usB sD card
reader while the usB card reader is still connected to the Q record.