American DJ 250

Accu Roller 250™ System Menu Accu Roller 250™ System Menu

American DJ® - www.americandj.com - Accu Roller 250™ Instruction Manual Page 26American DJ® - www.americandj.com - Accu Roller 250™ Instruction Manual Page 25

1. Access the main menu by pressing MODE/ESC.

2. Tap the UP button until “SPEC” is displayed, press ENTER.

3. Tap the UP button until “RDNI I” is displayed, press ENTER.

4. The display will show “ON/OFF”. Press the UP button to

select “ON” to activate this function, or “OFF” to deactivate.

5. Press ENTER to conﬁrm, and “PASS” will ﬂash quickly.

6. Press MODE/ESC to return to the main menu.

To use this function follow the instructions:

To adjust the address of your unit you must ﬁrst go to the

address that it is currently set to. From there you can adjust the

address. First make sure all channels are set to the value of “0”.

1. On your DMX controller set the DMX value of Channel 1 to

the value “7”.

2. Now set the DMX value of Channel 2 to the value “7” to

adjust the starting address between 1 and 255. To adjust the

address between 256 and 511 set Channel 2 to the value “8” .

3. Set the DMX value of Channel 3 to your desired start-

ing address. This will take about 20 seconds before the unit

accepts the new DMX address.

EXAMPLE: So, if you want the address to be 57, you must ﬁrst

set the address that is currently assingned to the unit. The pro-

ceed to set Channel 1s’ value to “7”, Channel 2s’ value to “7”,

and Channel 3s’ value to “57”.

2ND EXAMPLE: Again, if you want the address to be 420, you

must ﬁrst set the address that is currently assingned to the unit.

If you want the set the address to 420, set Channel 1s’ value to

“7”, Channel 2s’ value to “8”, and Channel 3s to “164”. (256 +

164 = 420)

SPOT - With this function you can adjust the lamp via

the control board. The shutter opens and the lamp can be

adjusted. In this mode, the device will not react to any con-

trol signal.

1. Access the main menu.

2. Tap the UP button until “SPEC” is displayed, press ENTER.

3. Tap the UP button until “SPOT” is displayed, press ENTER.

4. The display will show “ON/OFF”.

5. Press the UP button to select “ON” to activate this function,

or “OFF” to deactivate this function.

6. Press ENTER to conﬁrm.

7. Press MODE/ESC to return to the main menu.

DFSE - With this function you can restore the factory

settings of the device. All settings will be set back to the

default values. Any edited scenes will be lost. When restor-

ing the factory settings the unit must be set to the address

that the unit was in when you started editing.

1. Access the main menu.

2. Tap the UP button until “SPEC” is displayed, press ENTER.

3. Tap the UP button until “DFSE” is displayed, press ENTER.

4. The display will show “ON/OFF”.

5. Press the UP button to display “ON” to activate this function,

or “OFF” to deactivate this function.

6. Press ENTER to conﬁrm.

7. Press MODE/ESC to return to the main menu.

When you exit this function, the unit will begin to reload

data.