American DJ Bar-T-Cue operation manual B. MASTER mode

9. F+SIGNAL SELECT+RESET BUTTONS

Press to perform a reset for the whole system, which enables to return to initial condition.

10.DMX indicator blinks when preheat is effective, otherwise lights.

11.SIGNAL indicator blinks when DMX signal is available and goes out when not available.

B.MASTER mode

When the MASTER indicator is on, this unit is used as a DMX chase controller.

1. BUTTONS 1, 2, 3 and 4

1.Press to enable to display desired channel dimming level, corresponding indicator will blink, then select desired dimming level using UP or DOWN button.

These 4 buttons are effective only when MANUAL DIMMER indicator is on.

Press F+PRESET buttons to withdraw from this condition, the indicator won't blink.

2.UP BUTTON

Press to increase the display value.

3. DOWN BUTTON

Press to decrease the display value.

4.F+ BUTTONS(Press F andbuttons at a time.) Press to select L-- or R--.

NOTE: L-- refers to data information of CH.1,CH.2, CH.3 and CH.4 corresponding to 1, 2, 3 and 4 output. R-- refers to data information of CH.1, CH.2, CH.3 and CH.4 corresponding to 4, 3, 2 and 1 output.

5.F+D/S BUTTONS(Press F and D/S buttons at a time.) Press to select CRO or NOR.

NOTE: NOR refers to 0-100% dimming.

CRO denotes only FULL ON and STAND BY are available.When dimming level is greater than 50%, FULL ON is activated, otherwise, STAND BY is effective.

6.F+MODE BUTTONS

Press to select desired operating mode.

This function is effective only in MASTER mode. The operating modes are changed in order of:

MANUAL DIMMER	MANUAL PROGRAM	AUTO PROGRAM
AUTO SOUND	PROG SOUND	HOLD SOUND

7. F+SIGNAL SELECT BUTTONS

Press to select operating mode from MASTER to DMX mode, and the DISPLAY will show IN.

8. F+PRESET BUTTONS

Press to select available parameter information used with UP and DOWN buttons.

PARAMETER

F00-F99

P00-PFF

E00-E25

9. F+SIGNAL SELECT+RESET BUTTONS

FUNCTION

FADE TIME(0-10S)

DIMMER(0-100%)

PRESET MINIMUM DIMMING LEVEL(0-25%)

Press to perform a reset for the whole system, which enables to return to initial condition.

10.MASTER indicator blinks when preheat is effective.

11.SIGNAL indicator goes out.

12.FULL ON & STAND BY(Located on the remote control)

FULL ON and STAND BY are effective only in MASTER mode. Press FULL ON to activate full on function of whole channel output, DISPLAY shows FUL. Press STAND BY to turn off whole channel, and STD appears.

WARNING

1.This apparatus must be earthed.

2.To prevent fire or shock hazard, do not expose this apparatus to rain or moisture.

3.Wait for at least one second to turn the main power on after turning off the main power.

4.If malfunction occurs, reset to restart this unit.

5.This apparatus is suitable for normal pollution situation.

6.When this apparatus is used in connection with other unit, Start Code is 55H(85D)

7.When the current of whole unit exceeds max. permit table current, external circuit breaker will shut down the circuit automatically.