Operation
Modes
Important Notice: When setting or changing your dip switches it is best to discon- nect power so the unit can reset to the new settings.
Stand Alone Operation:
This operation is used to control one or more fixtures to the built in programs. Use this operation mode if; 1) You will not be using a DMX controller or 2) You do not wish to run your fixtures to sound or 3) You have more than one (1) Mighty Scan™ and you do not want to run them to a synchronized light show.
1.In
2.Flip dip switches one (1) and ten (10) to the on position (See diagram 1).
3.The units will now operate independently of each other to their built in programs.
Stand Alone Synchronized Operation:
This operation is used to synchronize two or more fixtures to the built in programs. Use this operation mode if; 1) You will not be using a DMX controller or 2) You do not wish to run your fixtures to sound or 3) You have more than one (1) Mighty Scan™ and you want to run them as a synchronized light show.
1.This operation will depend on a master unit to feed data instruction to other Mighty Scans.™
2.You may use 15 Mighty Scans, as slaves without the use of a controller (Total of 16; one master and 15 slaves).
3.Any unit may act as a Slave or a Master.
4.Use XLR cable to link your fixtures together. These cables must be daisy chained and can not be “Y’ed” or split.
5.Remember that the Male XLR connection on the fixture is the input and the female is the out- put. With this in mind, your first fixture will not have anything connected to the male XLR and the last fixture will not have any thing connected the female XLR connector.
6.Flip dip switches one (1) and ten (10), on the unit that will act as the master (the unit that has only an XLR cable coming out of female connector), to the on position (See diagram 1).
7.Be sure the dip switches from all the other units in the chain are all set to the off position.
8.The units will now run the built in programs in a synchronized light show.
Note: When running the Mighty Scans™ to the internal programs the fixture may not always be doing the same thing, this is not a malfunction, the internal pro- grams sometimes have the lights move independent of each other for a more dra- matic effect.
Sound Active Mode:
This operation is used to control one or more fixtures to the built in programs via sound. Use this operation mode if; 1) You will not be using a DMX controller or 2) You wish to run your fixtures to sound or 3) You have more than one (1) Mighty Scan™ and you do not want to run them as a syn - chronized light show.
1.In Sound Active mode the fixtures will run through the built in program via the beat of the music. Each Mighty Scan in your show will act as a separate unit not relying on any other unit for operation.
2.Flip dip switch ten (10) to the on position (See diagram 2).
3.The units will now runtheir built in programs independently of each other.
American DJ Supply® www.americandj.com MIGHTY SCAN™ User Instructions page 3
