Super Jewel™ Operation
Power Supply: Before plugging your unit in, be sure the source
voltage in your area matches the required voltage for your American
DJ® Super Jewel™ before attempting operation.
General Operation: Just plug this light in, and watch it go. This
fixture is designed to operate as a stand alone unit. It has been tested
and the lamp has been installed at the factory there is no assembly
necessary. The Super Jewel™ is ready to be plugged in right out of
the box. There is no power switch, after plugging the unit the select a
desired operating mode. To enhance the beam output use this fixture
with a fog machine to create 3-dimensional vibrant beams of light
Operating Modes:This unit comes with a 3-way multi-operating switch located on the
rear of the unit. The switch controls three (3) different operating
modes; Static, Sound Active, and Continuous Rotation.
Switch in the "I" position: Mode 1 - In this mode the internal dichroic
colored mirror dish will spin continuously in one direction, regardless
of the presence of sound.
Switch in the “0” position: Mode 2 - In this mode the internal dichroic
colored mirror dish will remain static. In this mode the unit may be
used in multiple on a chaser.
Switch in the “II” position: Mode 3 - In the this mode the internal
dichroic colored mirror dish will react to sound. Please note that
tapping on the unit, or high pitched sounds may not trigger the unit,
the unit is designed to react to low frequencies (bass). Also note that
the music sensitivity is preset at the factory and may not be changed
or adjusted.
Focusing:The unit has a fully focusing lens. To focus the lens; locate the lens
retaining thumb screw on the bottom of the unit. Loosen the lens
thumb screw and use the screw to slide the lens back and forth to
achieve the best possible focus. When the unit has been properly
focused tighten the thumb screw.
©American DJ® - www.americandj.com - Super Jewel™ Instruction Manual Page 7
Super Jewel™ Fuse & Lamp Replacement
Caution: Always replace with the exact same type lamp and fuse,
unless otherwise specified by an authorized American DJ® technician.
Replace with anything other than the specified part can damage your
unit and will void your manufactures warranty.
Warning: If after you have replac ed the lam p or fuse and you
continue to blow either one, STOP using the unit. Contact customer
support for further instructions, you may have to return the un it for
servicing. Continuing to use the unit may cause serious damage.
Fuse Repla cement: D isconnect the unit’s main power supply. Insert
a standard flat head screw driver in to the fuse holder housing (located
on the rear of the unit). Turn the screwdriver in a counter-clockwise
direction to remove the fuse holder. Remove the old fuse and discard
it, replace the fuse with the same type. Insert the fuse holder back
into it’s housing and turn in clockwise direction to lock the holder in
place.
Lamp Replacement: Caution! Never open the unit when in use.
Always disconnect the main power and allow the fixture ample time
to cool before attempting to replace the lamp. Lamp replacement has
been made simple by incorporating a split dome that is retained by
thumb screws. Again, please remember to always replace with the
exact same type lamp.
1. Be sure to follow the proper procedures when handling halogen
lamps. Never touch the new lamp with your bare fingers.
2. Loosen the two thumb screws (6 located on the sides of the unit.
3. Once the thumb screws have been loosened, pull back the lamp
assembly cover plate (6) to expose the lamp (11).
4. Remove and replace the lamp with an exact match.
5. Reassemble in reverse order.
©American DJ® - www.americandj.com - Super Jewel™ Instruction Manual Page 8
Thumb screw
Lamp Cover
Lamp Assembly
Thumb screw