American Dryer A Series installation instructions Installation Instructions, Removal of cover

INSTALLATION INSTRUCTIONS

	DISCONNECT POWER BEFORE INSTALLING
WARNING:
	DESUNA LA ELECTRICIDAD ANTES DE HACER REPARACIONES

Note: Automatic dryers are not recommended for hair drying use.

1. Removal of cover:

A) Loosen tamper-proof screws using wrench supplied, turn clockwise (do not remove). Located under bottom intake vent.

B) To remove, place a hand on each side of cover and lift upward, then pull off.

2. Dryers should be placed at least 2 feet (61cm) apart and at least 12” (30cm) from washbasin. Do not install dryer over washbasin. Automatic dryers should be at least 18” (46cm) above any projection which may interfere with the operation of the automatic sensor.

Hold the backplate to the wall at the suggested mounting height. Measure
from bottom edge of backplate to the floor (Ref. Dimension “A” Fig. 1):
MEN	WOMEN	CHILDREN	DISABLED
		(depends on age)
A-H Hair Dryer 72” (183cm)	68” (173cm)	46-68” (117-173cm)	52” (132cm)

3.Mark the locations of the four mounting holes and the conduit entrance location on the wall. (The conduit entrance is the proper hole diameter for 1/2 inch (13mm) conduit.)

4.Fasten the backplate to the wall where previously marked.

RECOMMENDATION:

Wood wall – No. 16 (M8) wood screws, 2 3/4” (70mm) long Cement or brick – 1/4” (M6) stud expansion bolts, 3” (76mm) long Hollow wall – 1/4” (M6) toggle bolts, length depends on wall thickness

5.Run service wire to the dryer location and connect to the terminal block. IMPORTANT: All units must be supplied with 3 wire service. Use No. 12 wire or larger, as required by local electrical code. The ground wire must be connected to the dryer backplate. Unit must be installed by a qualified licensed electrician.

Connect to a dedicated circuit NOT to exceed 20 amps.

Dryers located in shower rooms or other wet locations should be equipped with ground fault interrupter(s).

6.Carefully replace the cover using two tamper-proof bolts supplied, turn counter-clockwise. Be careful not to damage circuit board or sensor. Apply a bead of caulk around the edge of the cover to the wall.

AMERICAN DRYER, INC.

12932 FARMINGTON ROAD, LIVONIA, MI 48150, U.S.A.

Telephone (734) 421-2400  •  Fax (734) 421-5580

www.americandryer.com • Email: sales@americandryer.com

Revised Sptember 2006

OWNER’S MANUAL

“A” Series HAND and Hair DRYERS

For Installation or Service

Assistance Please Call

(734) 421-2400 or

Email: sales@americandryer.com

Important: Have Model & Serial No. Ready

# erialS # odelM

(86cm) 34” 102cm)-(76 40”-30 (102cm) 40” (107cm) 42” Dryer Hand - A

______

______