ADJUSTMENTS
7 DAYS AFTER INSTALLATION AND EVERY 6 MONTHS THEREAFTER
Inspect bolts, nuts, screws, setscrews, grounding connections, and nonpermanent gas connections (unions, shutoff valves, and orifices). Motor and drive belts should be examined. Cracked or seriously frayed belts should be replaced. Tighten loose
LUBRICATION
The motor bearings, idler bearings and under normal/most conditions the basket (tumbler) bearings are permanently lubricated. It is physically possible to relubricate the basket (tumbler) bearings if you choose to do so even though this practice is not necessary. Use Shell Alvania #2 grease or its equivalent. The basket (tumbler) bearings used in the dryer DO NOT have a grease fitting. Provisions are made in the bearing housing for the addition of a grease fitting which can be obtained elsewhere, or from ADC by ordering kit P/N 882159 (includes two [2] fittings).
DATA LABEL INFORMATION
When contacting American Dryer Corporation, certain information is required to ensure proper service/parts information from ADC. This information is on the data label that is affixed to the upper left side panel area behind the top control (access) door. When contacting ADC, please have the model number and serial number available.
THE DATALABEL
•MODEL NUMBER
The model number is an ADC number, which describes the size of the dryer and the type of heat (gas, electric, or steam).
•SERIAL NUMBER
The serial number allows ADC to gather information on your particular dryer.
•MANUFACTURING CODE NUMBER
The manufacturing code number is a number issued by ADC, which describes ALL possible options on your particular model.
•TYPE OF HEAT
This describes the type of heat for your particular dryer: gas (either natural gas or liquid propane [L.P.] gas), electric, or steam.
•HEAT INPUT (FOR GAS DRYERS)
This describes the heat input in British Thermal Units per Hour (Btu/hr).
•ORIFICE SIZE (FOR GAS DRYERS) Gives the number drill size used.
•ELECTRIC SERVICE
This describes the electric service for your particular model.
•GAS MANIFOLD PRESSURE (FOR GAS DRYERS)
This describes the manifold pressure taken at the gas valve tap.
www.amdry.com | 21 |
