3.Make a complete operational check of ALL the operating controls to ensure that the timing is correct and that the temperatures are set properly.
4.Make a complete operational check of ALL
NOTE: The sail switch can be checked for proper operation by opening the control door while the dryer is running and the heating unit (burner) active (on). The heating unit(s) should shut off within a few seconds. If not, make the necessary adjustments.
5.Each basket (tumbler) should be operated through one (1) complete cycle to assure that no further adjustments are necessary and that ALL components are functioning properly.
BASKET COATING
The basket (tumbler) is treated with a protective coating. We suggest dampening old garments or cloth material with a solution of water and nonflammable mild detergent and tumbling them in the basket (tumbler) to remove this coating.
6.Computer Programs and Selections
Each microprocessor controller (computer) has been preprogrammed by the factory with the most commonly used program (parameter) selections. If microprocessor controller (computer) program changes are required, refer to the computer programming manual, which was shipped with the dryer.
J.SHUT DOWN INSTRUCTIONS
In the case where the dryer is to be shutdown (taken out of service) for a period of time, the following must be performed:
1.Discontinue power to the dryer either at the external disconnect switch or the circuit breaker.
2.Discontinue the gas supply (for Gas Models Only):
a SHUT OFF external gas supply shutoff valve (for both the top basket [tumbler] and the bottom basket [tumbler] where the independent supply line for each basket [tumbler] is used).
b SHUT OFF internal gas supply shutoff valve located in the gas valve burner area (for both the top basket [tumbler] and the bottom basket [tumbler]).
24
