American Standard 1340.825, 1340.855, 1340.865 installation instructions Valve Assembly

VALVE ASSEMBLY (1340.825; 1340.855; 1340.865)

Install LOCKNUTS (1), METAL WASHERS (3) and RUBBER WASHERS (2) onto valve shanks.

Push TUBING (14) ends into VALVE (4) side outlets. Insert VALVES (4) into mounting holes from underside of ledge.

Press TEE (5) onto SPOUT SHANK (6) making certain that the O-RING (7) is properly seated on SHANK (6). Push COUPLING (8) into TEE (5) and attach to SPOUT SHANK (6) and tighten.

Thread of VALVE BODY (4) should extend at least 5/16 inch above MOUNTING SURFACE (11). If necessary, adjust LOCKNUT (1).

Place RUBBER RING (10) into ESCUTCHEONS (9) and thread onto valves until snug against internal stop.

Tighten LOCKNUT (1) to secure VALVE (4) position.	MOUNTING
	SURFACE
Slide FERRULE (12) and COUPLING NUT (13) to outlet of VALVE (4)
and tighten COUPLING NUT (13) firmly.

Place WASHER (16) on top of VALVE ASSEMBLY (4).

15

10

11

9

16 10

Thread VALVE ACTUATORS (15) onto VALVES (4) and torque VALVE
ACTUATOR 12-15 ft. lbs, (12-20Nm).				7
Connect water supply to VALVES (4) with 1/2" IPS FLEXIBLE SUPPLIES or
		12
3/8" O.D. BULL-NOSE RISERS. Use adjustable wrench to tighten connections.	4		13	6
Do not over tighten. Be careful not to kink copper supply when bending. Use
				16
tubing cutter to cut to proper length.
	HOT

	10	9			12
				14
5/16'' MIN.	4	11	MOUNTING	5
			SURFACE	8	4
	3	2		13	COLD
		1		1/2" IPS FLEXIBLE SUPPLIES or
				3/8" O.D. BULL-NOSE RISERS
				COUPLING NUT

￿￿VALVE ASSEMBLY (1340.725)

For Cold or Tempered Water Supply

Valve assembly is same as two handle lavatory faucets. See above instructions for assembly, (1340.725 Single Valve Faucet) is for Cold or Tempered water only.

10	9	MOUNTING	11
		SURFACE

15

9

10

5/16'' MIN.	4	11	MOUNTING	7
			SURFACE		16
		2		6
					12
	3	1		5

8	4
13	COLD OR
14
	TEMPERED

WATER

1/2" IPS FLEXIBLE SUPPLIES or	￿￿￿￿￿￿￿
3/8" O.D. BULL-NOSE RISER
COUPLING NUT