American Standard 1660.14 Install Supply Piping, “Installation Hole”, Install Plaster Guard

1			Turn off hot and cold water
	INSTALL SUPPLY PIPING	CAUTION
			supplies before beginning.

Provide a “Installation Hole” 2-1/8" - 2-3/8" DIA., (54-60mm) and 3-1/4", (83mm) deep. Note: The “Installation Hole” must be clear to allow body spray clearance.

Install the ELBOW (1) on a support within the wall at the *dimension shown. Secure with two M5 SCREWS (2) (not provided).

(2-	54-		60mm
	1/8"	-
			2-3/8"	DIA.)

2

	82.6mm
	(3-1/4")
83mm
(3	-1/4")
	1
	2
	54-60mm
	(2-1/8" - 2-3/8" DIA.)
	1
	“Installation Hole”
{“Installation Hole”
	*63.6-70.6mm
	(2-1/2" - 2-3/4")
	FINISHED WALL
	*75.6-82.6mm
	(2-15/16" - 3-1/4")
	WALL SUPPORT

2 INSTALL PLASTER GUARD

Make sure the O-RING (3) is installed on the PLASTER GUARD (1).

Install the PLASTER GUARD (1) into ELBOW (2). Note: The finished wall must be between the Min. & Max. lines on the PLASTER GUARD (1).

Complete all tiling and wall work. When walls are finished remove PLASTER GUARD (1).

		FINISHED WALL
	2	MAX.
3		(LINE MARK)

1	3
	2

INSTALL

REMOVE

1

MINIMUM

(LINE MARK)

M968617 Rev. 1. 2