6
BOLT CAP
CLOSET FLANGE |
INSTALL TOILET
a.Position toilet squarely to wall and, with a rocking motion, press bowl down fully on wax ring and flange. Alternately tighten nuts until toilet is firmly seated on floor.
!CAUTION:
DO NOT OVERTIGHTEN NUTS
OR BASE MAY BE DAMAGED!
b.Install caps on washers.
(If necessary, cut bolt height to size before installing caps.)
c.Smooth off the bead of sealant around base. Remove excess sealant.
WASHER | NUT CLOSET BOLT |
7
RUBBER
TANK MTG. 
GASKET BOLTS PRE-
INSTALLED
MTG.
RIBS
WASHER/NUT
INSTALL TANK
Recommended tool: Deep socket tool included in tank kit.
a.Install large rubber gasket over threaded outlet on bottom of tank and lower tank onto bowl so that tapered end of gasket fits evenly into bowl water inlet opening, and tank mounting bolts go through mounting holes. Secure with metal washer/nuts. Use the included deep socket tool to help get nuts started on bolts.
b.With tank parallel to wall, alternately tighten hex nuts keeping tank even and level until tank contacts both front and rear bowl mounting ribs. Do not tighten any further.
WASHER/NUT
DEEP SOCKET TOOL
SCREWDRIVER
DEEP
SOCKET
TOOLSCREWDRIVER
!CAUTION: DO NOT OVERTIGHTEN NUTS MORE THAN REQUIRED FOR A SNUG FIT! DO NOT SPIN BOLTS INSIDE TANK WITH A SCREWDRIVER
8 |
| INSTALL TOILET SEAT Install toilet seat in accordance with manufacturer's directions. |
|
|
|
9a | Before continuing, determine the type of water supply connection you have from the chart below and use the appropriate assembly parts | |
|
| required to properly reconnect the water supply. DO NOT use plumber's putty to seal these fittings. |
|
| |
METAL/COPPER | METAL FLANGED | METAL SPIRAL | VINYL/BRAIDED | |
FLARED TUBING |
| TUBING | TUBING | CONNECTOR |
LOCK NUT |
| LOCK NUT | LOCK NUT | LOCK NUT |
CONE |
| EXISTING | EXISTING | COUPLING |
| WASHER | |||
WASHER |
| CONE | NUT | |
COUPLING |
| EXISTING | WASHER |
|
|
|
| ||
NUT |
| COUPLING | COUPLING |
|
|
| NUT | NUT |
|
WATER |
| WATER | WATER | WATER |
| ||||
These parts must be used as illustrated | Use existing | Use existing spiral cone | Captive cone | |
to insure | coupling nut | washer. Fluidmaster | washers already | |
existing coupling nut may result in water | and washer. | cone washer may not | included. No | |
leakage. Water supply tube or pipe |
|
| seal completely on | additional washers |
must extend at least 1/2" inside |
|
| spiral type supply line. | needed. |
threaded shank of valve (does not apply |
|
|
| |
to flanged tubing). |
|
|
|
|
CAUTION: DO NOT USE CONE WASHER WITH PLASTIC SUPPLY LINE.
CAUTION: Overtightening of LOCK NUT or COUPLING NUT could result in breakage and potential flooding.
!WARNING: Do not use plumber’s putty, pipe dope, or any other sealant on the water supply connection to this tank. If the connection leaks after hand tightening, replace the supply line. If the connection continues to leak with the new supply line, replace the fill valve.
Warranty is void if any type of sealant is used on the water supply connection.
- 3 - |
