American Standard 2021.831 installation instructions 1FAUCET INSTALLATION, Valve Installation

T M

Installation Instructions

2021.831

KITCHEN FAUCETS

HI-FLOW SPOUT

Thank you for selecting American-Standard...

the benchmark of fine quality for over 100 years.

To ensure that your installation proceeds smoothly-- please read these instructions carefully before you begin.

Certified to comply with ASME A112.18.1M

M66241 REV.1.1

TOOLS REQUIRED

Channel Locks Adjustable Wrench Plumbers' Putty or Caulking Phillips Screwdriver

1 FAUCET INSTALLATION

CAUTION

Turn off hot and cold water supplies before beginning.

This faucet permits an interchangeable mounting of each integral component -- spout, valve, and hand spray-- to suit the particular installation requirements.

2 VALVE INSTALLATION

Remove VALVE NIPPLE (1),

SEAL WASHER (2), LOCKNUT (3) and MOUNTING ASSEMBLY (4) from threaded STUD (5) of valve.

8

RECESS

Before starting installation, place each component loosely into the holes of the kitchen sink to select the most desirable arrangement.

ROUGHING-IN

DIMENSIONS

9-9/16

12" MAX

10

7

5

Insert supply TUBES (6) and threaded

STUD (5) through hole in sink.

Make sure black RUBBER RING (7) is properly seated in recess of base.

4

Orient valve so that threaded STUD (5) is centrally located towards the rear of sink, then assemble MOUNTING ASSEMBLY (4) and thread LOCKNUT (3) onto STUD (5) from underside of sink.

12	8-9/16
MAX

Hand tighten LOCKNUT (3) and check

3

2-3/16		VALVE
		1-1/4 MIN DIA
DIA		MTG HOLE
2 DIA.		MTG SURFACE
1-1/16 MAX	1-1/4 MAX	1-3/4 MAX
27/32
DIA.
1-1/8 DIA
		C/L OF	13-7/8
		FLEXIBLE HOSE
		TO SPOUT

that rotation of HANDLE (8) from HOT	2
to COLD is centered. Secure valve	1
position by tightening LOCKNUT (3)
firmly (spread TUBES (6) for better
access to LOCKNUT (3).
Bend TUBES (6) to meet supplies. Use
palm of hand to support TUBES (6)
while bending to avoid kinking.
Attach VALVE NIPPLE (1) with SEAL	6
WASHER (2) to threaded STUD (5).

HOT COLD

3/8 OD COPPER

BENDABLE