3 SPOUT BASE INSTALLATION
Remove ESCUTCHEON (1) with RUBBER RING (2) and insert SPOUT BASE (3) through hole from underside of Sink. Threads
of SPOUT BASE (3) should extend at least
Place RUBBER RING (2) into ESCUTCHEON (1) recess and thread ESCUTCHEON (1) onto SPOUT BASE (3) until snug against
internal stop.
Turn SPOUT BASE (3) so that the side INLET NIPPLE (5) is directed towards valve. Center SPOUT BASE (3) and tighten LOCKNUT (4).
Place SEAL WASHERS (6) into coupling nuts of FLEXIBLE HOSE (8) and connect to side INLET NIPPLE (5) and VALVE NIPPLE (7).
1
2
SINK OR
MOUNTING3 SURFACE
RUBBER WASHER
4
7
6
6 5
8
5/16'' MIN.
4 SPOUT INSTALLATION
Check that both
Check that the DIVERTER PLUG (2) is free and can move up and down.
Push the SPOUT
Place SPRAY HOLDER (6) into the appropriate mounting hole, assemble WING NUT (7) onto shank of SPRAY HOLDER (6) from underside of sink and secure by tighting WING NUT (7).
Feed SPRAY HOSE (8) through SPRAY HOLDER (6) and attach COUPLING
NUT (9) of SPRAY HOSE (8) to HOSE ADAPTER (10). Tighten COUPLING
NUT firmly (9).
Make certain that SPACER WASHER (11) and RUBBER WASHER (12)
are attached to SPRAY HOSE (8) and thread SPRAY HEAD (13) to NUT (14). Tighten NUT (14) firmly.
13 3
12 11
5 | INSTALL | 14 |
|
|
2
1 4 
6
8
10 
7 
9
5 SUPPLY CONNECTIONS
Bend 3/8” SUPPLY TUBES to meet water supplies valves.
Use palm of hand to support TUBES while bending to avoid kinking.
Connect inlet TUBES to water supplies with appropriate connectors.
Connect left TUBE to HOT water supply, and the right TUBE to the
COLD water supply.
Note: If additional supply length is required, installer must purchase additional parts separately.
3/8 O.D.
SUPPLIES
COLD
HOT
COMPRESSION NUT
FERRULE
M66241 REV.1.2
