American Standard 2064.011 installation instructions POP-UP Drain, Remove Flange, Flange Gasket

2 POP-UP DRAIN	Fig. A.	Fig. B.
Remove CLEAR PLASTIC COVER (1).	1
Remove CARDBOARD SPACER (2) from under	3	DRAIN
DRAIN POP-UP (3).
		BODY
Tighten TAILPIECE (4) on DRAIN BODY before
installing DRAIN BODY. Fig. B.
	2	4

3 REMOVE FLANGE	Fig. A.		Fig. B.
Thread FLANGE (1) counter-clockwise and remove	1
FLANGE (1) and FOAM GASKET (2) from drain
body. Fig. A.
Thread LOCKNUT (3) clock-wise to bottom of
drain body. Push GASKET (4) down against
LOCKNUT (3). Fig. B.		2	4

3

4	INSTALL DRAIN FROM		5 TIGHTEN LOCKNUT
	BELOW FIXTURE
	From under side of BIDET		Tighten LOCKNUT (1) firmly with Adjustable
	install DRAIN BODY (1) up	4	Wrench or Channel Locks.
	through drain outlet.
	Note: No plumber’s putty	3
	or caulk is required.
	The CABLE ATTACHMENT	DRAIN
	POINT (2) must face towards	OUTLET
	the rear of the BIDET.	1	1
	Install FOAM GASKET (3) and
		2
	FLANGE (4) onto drain body
	from above BIDET and tighten
	FLANGE (4) firmly.
6 FLANGE GASKET		Fig. A.	Fig. B.
	Check DRAIN FLANGE in BIDET to ensure that		DOWN
	WHITE FOAM GASKET (3) is fully compressed
	and not visible. Fig. A.	DRAIN	1
		FLANGE
	POP-UP KNOB (1) must be fully down. Fig. B.
			1 WHITE FOAM
			GASKET
			NOT VISIBLE
			M968851 Rev.1.3
		2