American Standard 2064.011 installation instructions Speed Connect Drain, Install Faucet, Serin

Installation Instructions

SERIN™

2064.011

MONOBLOCK BIDET with

Speed Connect™ Drain

Congratulations on purchasing your American Standard faucet with Speed Connect drain, a feature found only on American Standard faucets.

Certified to comply with ANSI A112.18.1

M968851 Rev.1.3

Speed Connect Drain*

•Fewer parts, installs in less time

•Never needs adjustment

•Guaranteed to seal properly the first time, every time.

*Your new American Standard faucet is designed to work only with the Speed Connect drain.

To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin.

Recommended tools

Screwdriver Channel Locks Adjustable Wrench Tubing Cutter

1			Turn off hot and cold water
	INSTALL FAUCET	CAUTION
			supplies before beginning.

Seat SEAL (1) into under side of ESCUTCHEON RING (2).

Seat ESCUTCHEON RING (2) with collar facing up into groove in faucet base.

Feed FAUCET SUPPLIES (3), MOUNTING STUD (4) and DRAIN CABLE ASSEMBLY (8) through ESCUTCHEON RING (2) and the mounting hole of lavatory or mounting surface. Figure A.

From below, push GASKET (7) and RETAINING WASHER (5) onto MOUNTING STUD (4). Secure Faucet with MOUNTING NUT (6), pulling faucet to front of sink, so SUPPLIES (3) rests against mounting hole. Before final tightening, make sure collar on MOUNTING NUT (6) is seated into RETAINING WASHER (5). Figure B.

Adjust Faucet so that it is centered. Tighten MOUNTING NUT (6) to complete faucet mounting.

7

5

COLLAR ON	6
	4
MOUNTING NUT

Figure B

Figure A

GROOVE

(FAUCET2 BASE)

4 1

MOUNTING

SURFACE

3

5

8

1