3 |
|
| Place | 4 |
|
| Using a level, adjust the top left |
|
| ||||||
|
|
| the top |
|
|
| it is in the same vertical plane as the lower left |
|
|
|
|
|
| ||
|
|
|
|
|
|
| nut. (If wall surface is irregular, the three |
|
|
| Adjust the two lower |
|
|
| nuts must be positioned to allow a minimum 1/16" |
|
|
|
|
| |||
|
|
|
|
| |||
|
|
| face of nuts is flush with finished wall. |
|
|
| gap between fixture and wall surface.) |
Adjust waste horn to project 5/16" (7mm) from | FINISHED WALL | |
finished wall. | ||
| ||
FINISHED WALL | 1/16" (2mm) | |
| (IRREGULAR | |
| WALL SURFACE) | |
CLOSET |
| |
CARRIER |
| |
SYSTEM |
| |
(3) NUTS | LEVEL | |
| ||
WASTE |
| |
HORN |
| |
5/16 (7mm) |
|
5 |
|
|
|
|
| ||
|
|
|
|
| |||
|
|
|
| NOTE: Bearing nuts and washers must be set | If inspection of this | ||
|
|
| |||||
|
|
| |||||
|
|
|
| to take full loading from the fixture allowing | initial installation, confirms that it is defective in materials or workmanship, American- | ||
|
|
|
| 1/16" (2mm) clearance between fixture and wall. | Standard will repair or, at its option, exchange the product for a similar model. | ||
|
|
|
| This warranty does not apply to local building code compliance. Since local | |||
|
|
|
|
| |||
|
|
|
|
| building codes vary considerably, the purchaser of this product should check with a | ||
|
|
|
| Follow support manufacturer's recommended | local building or plumbing contractor to insure local code compliance before | ||
|
|
|
| ||||
|
|
|
| installation. |
|
| |
|
|
|
|
| |||
|
|
|
| setting of closet outlet connection. | This warranty shall be void if the product has been moved from its initial place of | ||
|
|
|
|
| installation; if it has been subjected to faulty maintenance, abuse, misuse, accident or | ||
|
|
|
| Place felt or neoprene gasket (wax ring not | other damage; if it was not installed in accordance with | ||
|
|
|
| instructions; or if it has been modified in a manner inconsistent with the product as | |||
|
|
| shipped by |
|
| ||
|
|
|
| recommended) on closet outlet. |
|
| |
|
|
|
| ||||
|
|
|
|
| |||
|
|
|
|
| does not cover any labor or other costs of removal or installation, nor shall American- | ||
|
|
|
| When the fixture is installed, closet outlet | Standard be responsible for any other incidental or consequential damages | ||
|
|
|
| ||||
|
|
|
| attributable to a product defect or to the repair or exchange of a defective | |||
|
|
| |||||
|
|
|
| gasket must be compressed sufficiently to | product, all of which are expressly excluded from this warranty. (Some states or | ||
|
|
|
| assure a gas and watertight seal. | provinces do not allow the exclusion or limitation of implied warranties, so this | ||
|
|
|
| exclusion may not apply to you.) |
|
| |
| The following steps require a helper: | This warranty gives you specific legal rights. You may have other statutory rights | |||||
| that vary from state to state or from province to province, in which case this warranty | ||||||
|
|
|
|
| does not affect such statutory rights. |
|
|
|
|
|
| Install bowl on support using cap nuts and fiber | For service under this warranty, it is suggested that a claim be made through the | ||
|
|
| |||||
|
|
| |||||
|
|
|
| washers with the | contractor or dealer from or through whom the product was purchased, or that a | ||
|
|
|
| service request (including a description of the product | model and of the defect) be | ||
|
|
|
|
| |||
|
|
|
|
| sent to the following address: |
|
|
|
|
|
| DO NOT APPLY TOP RIGHT FIBER WASHER | In the United States: |
| In Canada: |
|
|
|
| ||||
|
|
|
| ||||
|
|
|
| AND CAP NUT UNTIL OTHER CAP NUTS |
| ||
|
|
|
| American Standard Inc., |
| ||
|
|
|
| HAVE BEEN FIRMLY TIGHTENED USING A | P.O. Box 6820 |
| 2480 Stanfield Road |
|
|
|
| WRENCH. | Piscataway, New Jersey 08855 |
| Mississauga, Ontario |
|
|
|
| Attention: Director of Consumer Affairs | Canada L4Y 1S2 | ||
|
|
|
|
| For residents of the United States, | Toll Free: (800) | |
|
|
|
| Install top right cap nut with fiber washer and | warranty information may also be | ||
|
|
|
| obtained by calling the following | Toronto Area: (905) | ||
|
|
| |||||
|
|
|
| run up hand tight. Wrench tighten approximately | toll free number: (800) |
|
|
|
|
|
| 1/4 turn. |
|
|
|
|
|
|
| Apply sealant to gap between bowl and finished |
| In Mexico: |
|
|
|
|
| Customer Service Manager | |||
|
|
|
| wall. Remove excess sealant. | Ideal Standard, S.A. de C.V. | ||
|
|
|
| Via Morelos #330 |
| ||
|
|
|
|
|
| ||
|
|
|
|
| Col. Santa Clara |
| |
|
|
|
|
| Ecatepec 55540 Edo. Mexico | ||
730484 - 100 | - 2 - |
