American Standard 2645LA, 2422LA, 2422VA, 2771V, 2771LA, 2645VA Cleaning and Maintenance, Install

ELECTRICAL CONNECTIONS

Install a separate 120VAC / 15AMP dedicated circuit with GFCI (Ground Fault Circuit Interrupter) protection.

At initial start-up with power ON, push the GFCI test button. The reset button should pop out. Push this button in to reset. If the GFCI fails to operate in this manner, there is a ground fault or malfunction, indicating the possibility of electrical shock. Turn off the power and do not use the bath until the source of the problem has been identified and corrected.

1.Route two separate branch circuits to the junction box near the whirlpool as shown in Figure 2. Each branch circuit MUST BE GFCI PROTECTED and must use copper conductors only.

2.Ensure the heater and pump are properly GROUNDED and BONDED as required. Attach the 8 AWG solid copper conductor supplied with the heater from the heater bonding lug to the motor frame bonding lug as shown in Figure 3. The conductor is secured to the lugs using set screws. The motor frame shall have a second 8 AWG solid copper conductor connected from the frame bonding lug to the homes electrical panel or approved local bonding point as shown in Figure 3.

Fig. 2			SEPARATE		Fig. 3
		15 AMP GFCI OUTLET		ELECTRICAL INSTALLATION
120 VAC					(HEATER)
WHITE	BLACK

	HEATER ON
E-Z INSTALL	HEATER
™	WHIRLPOOL

			(PUMP/MOTOR)
	GND.
		HEATER	RUN 8 AWG SOLID COPPER
			CONDUCTORS FROM
			HEATER BONDING LUG TO
	SEPARATE 15 AMP GFCI OUTLET		PUMP/MOTOR FRAME LUG
	for 1.6 H.P. PUMP		AND FROM PUMP/MOTOR
	SEPARATE 20 AMP GFCI OUTLET		LUG TO APPROVED
			GROUND AS SHOWN
	for2.1 H.P. PUMP
120 VAC
			FIRST COPPER
WHITE	BLACK		CONDUCTOR
			SECOND
			COPPER
			CONDUCTOR
			PUMP/MOTOR FRAME WITH
			BONDING LUGS

TO GROUND

PUMP/MOTOR

GND.

ELECTRICAL DIAGRAM

READ AND FOLLOW ALL INSTRUCTIONS

Your American Standard whirlpool is designed to give you many years of pleasure with reasonable care and maintenance.

Your new acrylic bathtub is tough, durable and easy to care for. The colors have been formulated to match other American Standard fixtures and enhance your choice of bathroom decorations. The high gloss surface will retain its lasting luster with proper care and maintenance.

CLEANING AND MAINTENANCE:

•Always fill the tub with temperate water. Excessively hot water (greater than 130˚ F) may cause surface damage.

•Remove bath mat after use and hang to dry. Allowing bath mat to dry in the tub may cause surface damage.

•Clean after use with a mild liquid household detergent cleaner. Do not turn on jets when such cleaners are present. Do not use: Lestoil® Cleaner; Lysol® Disinfectant (spray or concentrate); or Lysol® Basin, Tub and Tile Cleaner; Windex® Cleaner; Mr. Clean® Cleaner; Dow® Disinfectant Bathroom Cleaner*; or other cleaning products in aerosol cans.

•No Soap or Oils: Do not operate the whirlpool circulation system when using soap, bath oil or a bubble bath, or if such

substances are in solution in the bathwater. If introduced into the circulation system, they are likely to cause excessive foaming. Bathe with soap or oil only when whirlpool circulation system is off. Drain whirlpool after each use.

753782-100 Rev. B