4 |
| 5 |
| SEALANT | WAX RING |
| NUT | |
|
| |
|
| TAPERED |
|
| WASHER |
|
| CLOSET |
|
| BOLT |
|
| FLANGE |
INSTALL WAX SEAL |
|
|
| |
POSITION TOILET ON FLANGE | ||||
Invert toilet on floor (cushion to prevent | ||||
damage), and install wax ring evenly around | a. Unplug floor waste opening and install toilet on closet flange | |||
waste flange (horn), with tapered end of ring |
| so bolts project through mounting holes. | ||
facing toilet. Apply a thin bead of sealant | b. Loosely install retainer washers and nuts. Side of washers | |||
around base flange. |
| marked "THIS SIDE UP" must face up! | ||
6
BOLT CAP
CLOSET FLANGE |
7a | For Tanks/Bowls using Speed |
| Connect System (Tank |
mounting bolts
TANK MTG. | RUBBER | |
GASKET | ||
BOLTS PRE- | ||
| ||
INSTALLED |
|
WASHER
NUT
7b For all other Tanks/Bowls
RUBBER
WASHER
RUBBER
TANK MTG. 
GASKET BOLTS 
WASHER
NUT
CLOSET BOLT
WASHER NUT
INSTALL TOILET
a.Position toilet squarely to wall and, with a rocking motion, press bowl down fully on wax ring and flange. Alternately tighten nuts until toilet is firmly seated on floor.
!CAUTION:
DO NOT OVERTIGHTEN NUTS
OR BASE MAY BE DAMAGED!
b.Install caps on washers. (If necessary, cut bolt height to size before installing caps.)
c.Smooth off the bead of sealant around base. Remove excess sealant.
INSTALL TANK
a.Install large rubber gasket over threaded outlet on bottom of tank and lower tank onto bowl so that tapered end of gasket fits evenly into bowl water inlet opening, and tank mounting bolts go through mounting holes. Secure with metal washers and nuts.
b.With tank parallel to wall, alternately tighten nuts until tank is snugged down evenly against bowl surface.
!CAUTION:
DO NOT OVERTIGHTEN NUTS MORE THAN REQUIRED FOR A SNUG FIT!
INSTALL TANK
a.Install large rubber gasket over threaded outlet on bottom of tank and lower tank onto bowl so that tapered end of gasket fits evenly into bowl water inlet opening.
b.Insert tank mounting bolts and rubber washers from inside tank, through mounting holes, and secure with metal washers and nuts.
c.With tank parallel to wall, alternately tighten nuts until tank is snugged down evenly against bowl surface.
!CAUTION:
DO NOT OVERTIGHTEN NUTS MORE THAN REQUIRED FOR A SNUG FIT!
8INSTALL TOILET SEAT Install toilet seat in accordance with manufacturer's directions.
- 2 - |
