American Standard 2460.XXXW Series Electrical Diagram Read and Follow ALL Instructions

ELECTRICAL INSTALLATION INSTRUCTIONS

All wiring must be performed by a licensed electrician in accordance with the national electrical code and all other applicable codes.

WARNING:

When using electrical products, basic precautions should always be observed, including the following:

1.DANGER: RISK OF ELECTRIC SHOCK

Connect only to a circuit protected by a ground-fault circuit interrupter.

2.Grounding is required. The unit should be installed by a licensed electrician and grounded.

3.Install to permit access for servicing.

4.All building materials and wiring should be routed away from the pump body and heater (if equipped).

The whirlpool should be installed on a 120 vac, 15 amp dedicated circuit. The circuit should be hard-wired from the electrical power supply panel. The circuit must be a three (3) wire circuit from the electrical supply panel. A grounded neutral wire and a third wire, earth ground, are essential. ADDING THE SAFE-T-HEATER REQUIRES A SEPARATE 15 AMP MAXIMUM GFCI CIRCUIT.

ELECTRICAL INSTALLATION
	SEPARATE 15 AMP
	GFCI OUTLET
	120 VAC
	WHIRLPOOL MOUNTED
	AIR SWITCH or
	WALL TIMER
WHITE	BLACK
	PUMP/MOTOR
	GND.

ELECTRICAL DIAGRAM

READ AND FOLLOW ALL INSTRUCTIONS

791033-100 Rev. I (3)