3 INSTALL POP-UP DRAIN
Push Tail piece (11) down into Trap (C) (threaded end up).
Thread Locknut (5), Washer (4) and Gasket (3) (Bevel side up) onto Drain Body (10).
Apply a bead of Putty (D) to underside of Flange (2).
Feed Drain Body (10) up through Sink (A) and thread the Flange (2) fully onto Drain Body (10).
Tighten Locknut (5) firmly, keeping the pivot rod hole pointed towards the back of the sink.
Assemble Pivot Rod (9) as shown in
Insert Pivot Rod (9) into Drain Body (10) and tighten Pivot Nut (F).
Push TAILPIECE INSERT (12) into TAILPIECE (11) and push TAILPIECE up and thread tightly into DRAIN BODY (10).
Position Extension Rod (7) onto
Remove one end of Clip (8) from Pivot Rod (9) by squeezing ends together while sliding.
Insert Pivot Rod (9) into second or third hole in Extension Rod (7) and reassemble Clip (8).
Drop Stopper (1) into Drain Body (10).
1
2
A
3
4
5
10
12
11
"O" RING 
D
E
6
7
F
8
C
F
Adjust stopper height by repositioning Extension Rod (7) and tightening Thumbscrew (6).
GFIGURE-4B:
4 TEST INSTALLED FITTING
With HANDLES (1) in OFF position, turn on WATER SUPPLIES (2) and check all connections for leaks.
Remove AERATOR (3).
Operate both HANDLES to flush water lines thoroughly.
Replace AERATOR (3). | 1 |
1
3
5 CHECK DRAIN CONNECTIONS
Operate
Release DRAIN STOPPER (1) and check all drain connections and "P" trap for leaks. Tighten if necessary.
2
3
1
2
6 CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.
M 9 6 8 2 8 6
