American Standard 2555.901 installation instructions Installation Instructions, Townsquare

TOWNSQUARE

DECK-MOUNT BATH FILLER

with EverClean™ Finish

Congratulations on purchasing your American Standard faucet with EverClean finish found only on American Standard faucets.

Installation Instructions

2555.900

2555.901

EverClean Finish

•One wipe effortlessly removes spots

•Eliminates the need for cleaners and scrubbing

•Permanent surface protectant remains beautiful for the life of the faucet

•EverClean™ available on: Polished Chrome, Satin Nickel,

Stainless Steel, Polished Brass (or any combination of these finishes)

Certified to comply with ANSI A112.18.1M

.      
3 F W 
  

To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin.

IMPORTANT NOTICE TO INSTALLER!

Please check with local Code Authority for the installation requirements of this product. Some codes require an additional temperature mixing valve to limit the maximum hot water temperature and vacuum breaker

(for products with hand spray) to be installed with this product.

Required Tools		ROUGHING-IN
		DIMENSIONS		ADJ. 6-1/2 TO 12
		8-1/4
Phillips Screwdriver
					MOUNTING
	Adjustable Wrench	3-5/8			SURFACE
Flat Blade Screwdriver		1-1/8 D.		1-1/4
				MAX.
					1-1/2 MAX.
				3
		4			1-3/16 D.
Channel Locks	Wrench		(H)	(C)
	(Supplied)	3/4-14 MALE		12 MAX
			1-1/16 D.
		N.P.T. INLETS
1 SPOUT ASSEMBLY		2 PREPARE TUBE AND TEE ASSEMBLY

		CAUTION		Prepare TUBE and TEE ASSEMBLY (1) to fit center to center
	Turn off hot and	cold water supplies	before beginning.	VALVE (2) location (between 6-1/2" and12"). If necessary,
				cut and/or bend TUBING carefully. Make sure tube bend is
Insert SPOUT SHANK (1) through center hole of MOUNTING LEDGE.				close to the TEE (1) so that it will not effect the compression
Make sure that the RUBBER RING (2) is properly seated in RECESS				joint at the VALVE CONNECTION.
at base of SPOUT (3).				Remove COUPLING NUT (3) and FERRULE (4) from each
Assemble RUBBER WASHER (4) and BRASS WASHER (5) onto
				VALVE (2) and slide onto TUBING (5).
SHANK (1). From underside of ledge secure SPOUT (3) into position
with LOCKNUT (6).

3		2
RECESS		4
1		3
		ADJ. 6-1/2 TO 12
		1
2	MOUNTING	5
	LEDGE.	3

4

4

5

6

NOTE VALVE inlet is 3/4-inch NPT male connector.