1 INSTALL FAUCET
CAUTION
Turn off hot and cold water supplies before beginning.
Place faucet in position on sink.
Assemble and tighten LOCKNUTS from underside of SINK.
Connect the HOT water supply to the left SHANK and the COLD water supply to the right SHANK using appropriate connectors and sealant (not supplied), and COUPLING NUTS.
BODY
SHANK
PUTTY 
PLATE
SINK
COLD
LOCKNUT
HOT
NOT SUPPLIED
COUPLING NUT
2 TEST INSTALLED FAUCET
Remove AERATOR.
With handles in OFF position, turn on water supplies and check all connections for leaks.
Operate both handles to flush water lines thoroughly.
Turn handles into OFF position and replace AERATOR.
3 SERVICE
STOP
WASHER
To change direction of handle rotation, proceed as follows:
Turn valve to OFF position.
Pull out INDEX CAP and remove
HANDLE SCREW.
Pull off HANDLE BASE and remove
ADAPTER.
Remove SPRING CLIP.
Lift STOP WASHER, turn 90$ and replace.
Replace SPRING CLIP.
Reinstall HANDLE.
90$
SPRING
CLIP
Handle alignment.
Check alignment, if not satisfactory aligned;
Push out ADAPTER carefully.
Turn ADAPTER either 45˚ or 90˚ so that male square on ADAPTER catches different female square in HANDLE BASE.
Assemble and tighten
MOUNTING SCREW.
Push INDEX CAP in top of
HANDLE.
FEMALE SQUARE 
IN HANDLE BASE
HANDLE
ADAPTER
SQUARE
VALVE
STEM
AERATOR may accumulate dirt causing distorted and reduced water flow. Remove AERATOR and rinse clean.
If spout drips, operate handles several times from OFF to ON position. Do not force - handles turn only 90$.
4 EverClean™ Finish Care Instructions
American Standard’s EverClean finish will wipe clean with a soft, dry cloth. A soft cloth with clean water may also be used, if desired. No additional cleaning products are required.
DO NOT USE: Soaps, acid, polish, abrasives, harsh cleaners, or a cloth with a coarse surface.
. 3 & 7
