American Standard 2805EC dimensions General Specifications for 2805E Whirlpool

WILLIAMSBURG ELITE™ 5’ x 42”

WHIRLPOOLS BY AMERICAN STANDARD

HIGH GLOSS ACRYLIC

	1524mm
	(60)
762mm	INTEGRAL
	FITTING DECK	152mm
(30)
		(6)
305mm		C/L OF
(12)
		DRAIN
		PUMP
1067mm	178mm x 381mm
	(7 x 15)
(42)
	FLOOR
		PROVIDE ACCESS
	CUTOUT
		TO PUMP FOR
		SERVICE ON ALL
		INSTALLATIONS
		ON/OFF
		SWITCH
		19mm
		(3/4)
	OUTLINE OF CUTOUT
	1486mm x 1029mm
	(58-1/2 x 40-1/2)

IN-LINE HEATER

51mm(2) REMOVABLE BLANK

546mm (21-1/2)

495mm (19-1/2)

ROUGH INTEGRAL

FLOOR FEET

LEVELING STRINGER

NOT FOR SUPPORT

133mm (5-1/4)

C/L OF

OVERFLOW

64mm (2-1/2)

1-1/2 N.P.T.

THREADS

1-1/2 O.D.

TAILPIECE121mm (4-3/4)

GENERAL SPECIFICATIONS FOR 2805E WHIRLPOOL

INSTALLED SIZE		60 x 42 x 21-1/2 In. (1524 x 1067 x 546mm)
WEIGHT					130 Lbs. (59 Kg.)
WEIGHT w/WATER					689 Lbs. (310 Kg.)
GAL. TO OVERFLOW					64 Gal. (243 L)
WHIRLPOOL MIN. OPERATING VOL.					52 Gal. (197 L)
BATHING WELL AT SUMP					43 x 22 In. (1092 x 559mm)
BATHING WELL AT RIM			55 x 35-1/2 In. (1397 x 902mm)
WATER DEPTH TO OVERFLOW					14 In. (356mm)
FLOOR LOADING				39 Lbs./Sq.Ft. (191 Kgs./Sq.m)
(PROJECTED AREA)
PTS.						27.8
CUBE (FT3)							47.4
	WHIRLPOOL ELECTRICAL SPECIFICATIONS
PUMP					1.6 HP, 9.7 AMPS ,120V.

NOTES:

BATH CAN BE INSTALLED EITHER ABOVE OR BELOW FLOOR LINE AS PIER, ISLAND, OR PENINSULA TYPE INSTALLATION. SUMP OF BATH IS SUPPORTED BY INTEGRAL FEET. NO ADDITIONAL SUPPORT REQUIRED. ENCLOSING MATERIAL BY OTHERS.

■REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH WHIRLPOOL FOR ADDITIONAL INFORMATION.

OPTIONAL 3- WALL TILING BEAD KIT No. TILE-BEAD AND APRON WBURG5-APRON MUST BE ORDERED SEPARATELY.

FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.

PROVIDE SUITABLE REINFORCEMENT FOR ALL SUPPORTS.

●IF INSTALLING A DECK-MOUNTED FITTING, BEFORE DRILLING ANY HOLES: CHECK FOR INTERFERENCE WITH CIRCULATING SYSTEM PIPING, DRAIN OVERFLOW. MOUNTING HOLES DRILLED BY INSTALLER.

SUPPLY PIPING NOT INCLUDED.

IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard Z124.1.These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages.

© 2003 American Standard Inc.