American Standard 2806.028WC, 2806.018WC dimensions Heritage Whirlpool, High Gloss, Revised 6/07

HERITAGE 6'™

WHIRLPOOL

HIGH GLOSS

1829mm

279mm(72) (11)

457mm	229 x 330mm	PUMP
(18)	(9 X 13)
	FLOOR
	CUTOUT

908mm (35-3/4)

INTEGRAL	ON/OFF
FITTING DECK	SWITCH

140mm		OUTLINE OF			PROVIDE ACCESS
(5-1/2)	C/L OF
			CUTOUT	TO PUMP FOR SERVICE
	DRAIN
				ON ALL INSTALLATIONS
	OVERFLOW
C/L OF	108mm		LEVELING STRINGER
OVERFLOW	(4-1/4)		(NOT FOR SUPPORT)
					SAFE-T-HEATER
					REMOVABLE
	51mm				BLANK
					546mm
INTEGRAL	(2)				(21-1/2)
FEET					495mm
SUPPORT
					(19-1/2)
ROUGH
FLOOR
	1-1/2 N.P.T.M. THREADS
	1-1/2 O.D.TAILPIECE			51mm	108mm
					(4-1/4)
				(2)
	GENERAL SPECIFICATIONS FOR 2806 WHIRLPOOL
	INSTALLED SIZE	72 x 35-3/4 x 21-1/2 In. (1829 x 908 x 546mm)
	WEIGHT				135 Lbs. (61 Kg.)
	WEIGHT w/WATER			744 Lbs. (338 Kg.)
	GAL. TO OVERFLOW				73 Gal. (276 L)
	WHIRLPOOL MIN. OPERATING VOL.				44 Gal. (167 L)
	BATHING WELL AT SUMP		45 x 24 In. (1143 x 610mm)
	BATHING WELL AT RIM		60 x 30 In. (1524 x 762 mm)
	WATER DEPTH TO OVERFLOW				15 In. (381mm)
	FLOOR LOADING		41 Lbs./Sq.Ft. (198 Kgs./Sq.m)
	(PROJECTED AREA)
	PTS.				25.6
	CUBE (FT3)				49.4
	WHIRLPOOL ELECTRICAL SPECIFICATIONS
	SYSTEM I PUMP			2.1 HP, 14.4 AMPS ,120V.
	SYSTEM II PUMP			2.1 HP, 15.6 AMPS ,120V.

NOTES:

BATH CAN BE INSTALLED EITHER ABOVE OR BELOW FLOOR LINE AS PIER, ISLAND, OR PENINSULA TYPE INSTALLATION. SUMP OF BATH IS SUPPORTED BY INTEGRAL FEET. NO ADDITIONAL SUPPORT REQUIRED. ENCLOSING MATERIAL BY OTHERS.

■REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH WHIRLPOOL FOR ADDITIONAL INFORMATION.

▲CUTOUT TEMPLATE PROVIDED IN SHIPPING BOX. MAY BE REQUESTED SEPARATELY. OPTIONAL GRAB BAR KIT AVAILABLE AND MUST BE ORDERED SEPARATELY.

FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.

PROVIDE SUITABLE REINFORCEMENT FOR ALL SUPPORTS.

●IF INSTALLING A DECK-MOUNTED FITTING, BEFORE DRILLING ANY HOLES: CHECK FOR INTERFERENCE WITH CIRCULATING SYSTEM PIPING, DRAIN OVERFLOW, AND APRON INSTALLATION. MOUNTING HOLES DRILLED BY INSTALLER.

SUPPLY PIPING NOT INCLUDED.

IMPORTANT: Dimensions of fi xtures are nominal and may vary within the range of tolerances established by ANSI Standard Z124.1. These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages.

	H36
© 2007 American Standard Inc.		Revised 6/07