American Standard 2880.000 dimensions CADET 3 ROUND FRONT TOTAL Toilet, Compliance Certifications

CADET® 3 ROUND FRONT TOTAL TOILET

❑2880.000

•Vitreous china

•Low-consumption (6.0 Lpf/1.6 gpf)

•12" Rough-in (305mm)

•EverClean® surface inhibits the growth of stain and odor causing bacteria, mold and mildew on the surface

•Features the Cadet® 3 Flushing System

•Space saving round front siphon action jetted bowl

•Fully-glazed 2-1/8" trapway with 2" ball pass

•Generous 9" x 8" water surface area

•Close-coupled tank with flat tank cover for superior storage

•Oversized 3" flush valve with chemical resistant flapper

•Chrome trip lever

•Speed Connect® tank-to-bowl coupling system

•Sanitary dam on bowl with four point tank stabilization

•2 color-matched bolt caps

•Color matched solid plastic seat and cover with EverClean® surface

•Wax ring gasket with closet bolts

•100% factory flush tested

•5 year warranty

Nominal Dimensions: 718 x 438 x 733mm

(28-1/4" x 17-1/4" x 28-7/8")

Compliance Certifications -

Meets or Exceeds the Following Specifications:

•ASME A112.19.2M for Vitreous China Fixtures - includes Flush Performance, Ball Pass Diameter, Trap Seal Depth and all Dimensions

•Los Angeles Department of Water and Power Supplementary Purchase Specification for Non-Adjustability

102mm (4)

CADET® 3 ROUND FRONT TOTAL Toilet

VITREOUS CHINA

	718mm
FINISHED WALL	(28-1/4)
25mm ± 6mm
(1 ± 1/4)
216mm			438mm
			(17-1/4)
(8-1/2)
	416mm
	(16-3/8)
	C/L OF SEAT POST HOLES		733mm
	140mm (5-1/2 CENTERS)
		SUPPLY	(28-7/8)
		AS
		REQ'D.
		*381mm
		(15)
		*203mm	352mm
		(8)	(13-7/8)
216mm	333mm		235mm
		FINISHED	(9-1/4)
(8-1/2)	(13-1/8)
		FLOOR	*152mm
305mm	C/L OF OUTLET		(6)
(12)

To Be Specified:

❏Color: ❏ White

❏Supply with stop:

© 2008 AS America Inc.

NOTES:

THIS TOILET IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION OF 305MM (12") FROM FINISHED WALL TO C/L OF OUTLET.

SUPPLY NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED SEPARATELY.

*DIMENSION SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED.

IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.2.

These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages.

K100

Revised 2/08