American Standard 3770 Make Water Supply Connections, Test Installed Fitting, Service

3 MAKE WATER SUPPLY CONNECTIONS

NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS MUST BE PURCHASED SEPARATELY.

Connect water supply to FAUCET SHANKS (1) with 1/2" IPS FLEXIBLE SUPPLIES (2) or 3/8" O.D. BULL-NOSE RISERS (3).

Use adjustable wrench to tighten connections. Do not over tighten. Be careful not to kink copper supply when bending. Use tubing cutter to cut to proper length.

1

1

2

COUPLING NUT

3

FERRULE

4	TEST INSTALLED FITTING	5	SERVICE	STOP	90˚
				WASHER
	With HANDLES (1) in OFF position, turn on WATER		To change direction of handle rotation,
	SUPPLIES (2) and check all connections for leaks.
			proceed as follows:
	Remove AERATOR (3).		Turn valve to OFF position.
	Operate both HANDLES to flush water lines thoroughly.		Pull out INDEX CAP and remove
			HANDLE SCREW.
	Replace AERATOR (3).		Remove SPRING CLIP.		SPRING
			Lift STOP WASHER, turn 90˚ and replace.
			Replace SPRING CLIP.		CLIP
			Replace ADAPTER, HANDLE, SCREW, and INDEX CAP.
			AERATOR may accumulate dirt causing distorted and
			reduced water flow. Remove AERATOR and rinse clean.
			If spout drips, operate handles several times from OFF
			to ON position. Do not force - handles turn only 90˚.

3

1

1

ALIGN HANDLES

Pull out INDEX CAP (1) and remove	1
	2
HANDLE SCREW (2), HANDLE (3)
and ADAPTER (4).	3
Push ADAPTER (4) on VALVE STEM (5).
Find correct position of HANDLE (3) by
adjusting male teeth on ADAPTER (4) to	4
female teeth on HANDLE (3).
Replace HANDLE SCREW (2) and push	5
in INDEX CAP (1).

2

6 CARE INSTRUCTIONS:

DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.

DO NOT: CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.

M968935 Rev . 1 . 1