| Installation |
| Instructions |
COLONY SOFT | 3875.403 |
Spread Lavatory Faucet with | 3875.503 |
| |
SpeedConnect™ Drain |
|
Congratulations on purchasing your American Standard faucet with SpeedConnect drain, a feature found only on American Standard faucets.
SpeedConnect Drain*
•1/3 of the parts, installs in 1/3 of the time•No tools needed•Never needs adjustment
•Guaranteed to seal properly the first time, every time.
C
H
Certified to comply with ANSI A112.18.1
M968886
*Your new American Standard faucet is designed to work only with the SpeedConnect drain.
To ensure that your installation proceeds
Required tools |
|
|
|
| |
1 | Screwdriver | Channel Locks | Adjustable Wrench | Tubing Cutter | |
INSTALL SPOUT | CAUTION | Turn off hot and cold water | Fig. A. | ||
supplies before beginning. | |||||
|
|
|
|
Insert SPOUT (1) and CABLE CONNECTOR (2) through center hole, making sure the SEAL WASHER (3) is properly seated in SPOUT (1).
Assemble RUBBER WASHER (4), BRASS WASHER (5) and LOCKNUT (6) onto SPOUT SHANK (7) from under side of sink . Make sure SPOUT (1) is centered in the mounting hole and the slot in the BRASS WASHER (5) faces toward the rear of the sink.
Tighten LOCKNUT (6) firmly. Fig. A.
1A INSTALL VALVE BODY
Place RUBBER RING (9) into SCUTCHEON (10).
Install LOCKNUT (11) onto VALVE BODY (12).
From under side of mounting surface, install VALVE BODY (12) through valve mounting holes. Threads of VALVE BODY (12) should extent at least 5/16 of a inch above mounting surface top. Fig. B. Thread ESCUTCHEON (10) onto VALVE BODY (12) until snug against internal stop. If necessary, adjust LOCKNUT (11).
Hand tighten LOCKNUT (11) to secure VALVE BODY (12). Repeat above steps for opposite VALVE BODY (12A).
1
3
7
4
SLOT 5
6
2
5/16'' MIN.
Fig. B.10
9
MOUNTING 10
SURFACE
9
|
| 11 | 12 |
|
| ||
|
| 12 | |
|
| 11 | |
|
|
|
12a
1