American Standard 3985 installation instructions Deck-Mount Bath Filler, Series

Installation

Instructions

T M

3985 Series

DECK-MOUNT

BATH FILLER

Thank you for selecting American-Standard...the benchmark of fine quality for over 100 years.

To ensure that your installation proceeds smoothly--please read these instructions carefully before you begin.

Certified to comply with ANSI A112.18.1M

U.S. Patent No. 5,819,789; D405,165

					M968236 Rev . 1 . 2
Required Tools			ADJ. 6-1/2 TO 12
Flat Blade Screwdriver
*Hex key					6-5/8
Adjustable Wrench	MOUNTING				4-3/4
	SURFACE
	1-1/8 D.		1-1/4
			MAX.
				3	7-1/4
	4
Channel Locks
*Supplied with Fitting	3/4-14 MALE	(H)	1-1/16 D.	(C)
	N.P.T. INLETS

1 SPOUT ASSEMBLY

CAUTION

Turn off hot and cold water supplies before beginning.

Insert SPOUT SHANK (1) through center hole of MOUNTING LEDGE. Make sure that the RUBBER RING (2) is properly seated in RECESS at base of SPOUT (3).

Assemble RUBBER WASHER (4) and BRASS WASHER (5) onto SHANK (1). From underside of ledge secure SPOUT (3) into position with LOCKNUT (6).

3

RECESS1

2 MOUNTING LEDGE.

4

5

6

2 PREPARE TUBE AND TEE ASSEMBLY

Prepare TUBE and TEE ASSEMBLY (1) to fit center to center VALVE (2) location (between 6-1/2" and12"). If necessary, cut and/or bend TUBING carefully. Make sure tube bend is close to the TEE (1) so that it will not effect the compression joint at the VALVE CONNECTION.

Remove COUPLING NUT (3) and FERRULE (4) from each VALVE (2) and slide onto TUBING (5).

4

3

1

5

3

4

2

ADJ. 6-1/2 TO 12

NOTE VALVE inlet is 3/4-inch NPT male connector.