5 TEST INSTALLED FAUCET | 4 |
Move HANDLE (1) down into "off" position. | 5 |
Remove AERATOR (2). |
|
With HANDLE (1) down in "off" position, pull HAND SPRAY (3) |
|
from SPOUT (4). SPRAY (HOSE (5) should pull approximately 2 feet |
|
and direct open SPRAY END (3) into sink. |
|
Operate handle up and down, in COLD and HOT positions, | 1 |
to flush water lines thoroughly. |
|
Replace AERATOR (2). Place HAND SPRAY (3) back into FAUCET (4).
Check HAND SPRAY (3) operation:
With faucet on push BUTTON (6) for a broad cleansing spray. BUTTON (6) will lock into this position.
To unlock push opposite end of BUTTON (6). Faucet will return to standard spray.
6 
3
2
6 SERVICE | 3 | |
If faucet drips, operate HANDLE several times from "off" to "on." Do not | 2 | |
apply excessive force. | 1 | |
Clogged CARTRIDGE outlets or inlets may cause reduced flow. | ||
To clean, first turn off water supply then: | 4 | |
Remove INDEX BUTTON (1), loosen HANDLE SCREW (2) | ||
| ||
and remove HANDLE (3). |
| |
Unthread ESCUTCHEON CAP (4). Unthread three |
| |
MOUNTING SCREWS (5). |
| |
Lift CARTRIDGE (6) off MANIFOLD (7) and remove | 5 | |
CARTRIDGE SEALS (8). |
Clean MANIFOLD (7), CARTRIDGE (6) ports and SEALS (8).
Place SEALS (8) into CARTRIDGE PORTS (6a).
Place CARTRIDGE (6) onto MANIFOLD (7) and tighten MOUNTING |
| 6 |
SCREWS (5) alternately. | 6a | 8 |
Replace ESCUTCHEON CAP (4), HANDLE (3), tighten HANDLE | ||
SCREW (1) and install INDEX BUTTON (2). | 7 |
|
Test fitting.
7 CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.
M968584
