American Standard 4233.400  Make Water Supply Connections,  Test Installed Faucet,  Service

MAKE WATER SUPPLY CONNECTIONS

NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS MUST BE PURCHASED SEPARATELY.

Connect water supplies to SUPPLY ADAPTERS (1) with 1/2" IPS FLEXIBLE SUPPLIES (2) or 3/8" O.D. BULL-NOSE RISERS (3).

Use tubing cutter to cut to proper length.

Connect the HOT to the left supply and the COLD to the right supply.

Use adjustable wrench on coupling nut and another wrench on supply adapters to prevent twisting of supply tubes. Tighten connections. Do not over tighten. Be careful not to kink copper supply when bending.

1

3

2

FERRULE

HOT COLD

TEST INSTALLED FAUCET

Remove AERATOR (1). With handles in OFF position, turn on WATER SUPPLIES (2) and check all connections

for leaks.

Operate both HANDLES (3) to flush water lines thoroughly. Rotate SPOUT (4) in both directions. Replace AERATOR (1).

1 4

3

2

 SERVICE 2

To change direction of handle	1
rotation, proceed as follows:

Turn valve to OFF position.

Remove INDEX CAP (1). Remove

HANDLE SCREW (2).

Pull off HANDLE (3) and pull off

HANDLE BASE (4).

Remove SPRING CLIP (6).

Lift STOP WASHER (5), turn 90˚ and replace.

Replace SPRING CLIP (6).

Reinstall HANDLE BASE (4) and HANDLE

ASSEMBLY (3,2,1).

If faucet drips proceed as follows:

Aerator may accumulate dirt causing distorted and reduced water flow. Remove aerator and rinse clean.

If spout drips, operate handles several times from ON to OFF position. Do not force-handles turn only 90˚.

3

4 6

90˚

5

.      
3 & 7