2 MAKE WATER SUPPLY CONNECTIONS
Turn off hot and cold water supplies before beginning.
Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies. Connection on fitting supplies are 3/8" compression. Connect left supply (Marked with a Red Stripe) to Hot and right supply (Marked with Blue Stripe) to Cold wall supply. Use adjustable wrench to tighten connections. Do not over tighten.
Faucet supplies are
B L U E
R E DS T R I P E S T R I P E
2
Note: If additional supply length is required, installer must
purchase additional parts1 COLD separately.
Important: If SUPPLY HOSES
(1, 2) are too long, loop asHOT illustrated to avoid kinking.
3 TEST INSTALLED FAUCET
Move HANDLE (1) into "off" position.
Unthread SPRAY END (2) from SPOUT (3).
Turn on water supplies and check connections for leaks. | 3 |
Operate HANDLE (1) on and off, hot and cold to flush water lines thoroughly. Replace SPRAY END (2).
Check all drain connections for leaks. | 2 |
|
|
| 1 |
|
|
| |||
|
|
|
| ||
|
|
|
Move HANDLE (1) to "off" position.
HOT & COLD SUPPLIES
M 9 6 8 5 8 2