American Standard 4508.4 Attach Cable, Connector, Check Operation of POP-UP, Cold, Hot

2

7

FLEXIBLE

SUPPLIES

1/2" PIPE THREAD

8	ATTACH CABLE	Fig. A.	Fig. B.	Fig. C.
	CONNECTOR
	POP-UP KNOB (1) must be fully	DOWN
	down. Fig. A.		1
	Thread CABLE CONNECTOR (1)
	clockwise onto DRAIN BODY
	CONNECTION (2) and hand
	tighten. Fig. B.
	Your new POP-UP DRAIN
	installation is now complete.		2
	Fig. C.
	Note: Tailpeice on pop-up drain			1-1/4” O.D.
	is 1-1/4” O.D. Fig. C.
9 CHECK OPERATION OF POP-UP				5
	Operate LIFT KNOB (1) to verify that STOPPER (2)
	opens and closes.			4
	Note: If STOPPER (2) does not open and close properly		1	3
	then refer to the “troubleshooting section” of these			1
	instructions.
	INSTALL DIVERTER KNOB			2
	Push DIVERTER KNOB (1) onto HANDLE ADAPTER (2).		2

Push on RING (3) and tighten with SCREW (4).

Press on KNOB CAP (5).

Note: Screwdriver gap is for disassembling and should point downwards.

10 TEE AND HOSE CONNECTION

OUTLINE OF BIDET

Insert SEAL (1) into ADAPTER (2) and tighten ADAPTER (2) to side of TRANSFER VALVE (3).

Install SEAL (4) into coupling nut of TEE (5) and tighten connection to ADAPTER (2).

Connect HOSE COUPLING NUTS (6) to Hot and Cold valve bodies and securely tighten.

WATER SUPPLY CONNECTION

NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS NOT INCLUDED AND MUST BE PURCHASED SEPARATELY.

Connect water supply to VALVE BODIES (7,7a) with

1/2" IPS FLEXIBLE SUPPLIES (8) or 3/8" O.D. BULL-NOSE RISERS (9). Use adjustable wrench to tighten connections. Do not over tighten. Be careful not to kink copper supply when bending. Use tubing cutter to cut to proper length.

Connect HOT water supply to inlet of left SHANK and COLD water supply to right SHANK using sealant, appropriate connectors, and COUPLING NUTS.

Connect 1-1/4” O.D. tailpiece on POP-UP DRAIN to waste outlet.

5		6
	3		7a
4			COUPLING
	2		NUT
		Front
6	1		9
			3/8 O.D.
			BULL-NOSE
			RISERS
			COMPRESSION
			NUT
			FERRULE
			COLD
		CONNECT TO
		WASTE OUTLET
HOT	3/8 COMPRESSION
	CONNECTION

M968845 Rev . 1 . 2

3