9 INSTALL HANDLES |
|
|
|
Push ADAPTER (1) on VALVE STEM (2), so that the hole of the |
|
| |
ADAPTER (1) without a spline is facing up. Fig. A. Tighten |
| THREAD ON | |
STEM SCREW (3) to secure ADAPTER (1). |
|
| |
| 4 | TO DECK | |
|
| ADAPTER | |
Find correct position of LEVER HANDLE ASSEMBLY (4) by adjusting |
|
| |
male teeth on ADAPTER (1) to female teeth in HANDLE (4). | TOP |
| |
Thread LEVER HANDLE ASSEMBLY (4) onto DECK ADAPTER (5) |
| 1 | |
until snug against mounting surface. |
|
| |
Fig. A. |
|
| |
|
| 3 | |
|
|
| 2 |
| SPLINE END DOWN |
| 5 |
|
|
| |
10 TEST INSTALLED FITTING |
| 5 |
|
|
| 1 | |
With HANDLES (1) in OFF position, turn on WATER |
| ||
SUPPLIES (2) and check all connections for leaks. |
|
| |
Remove AERATOR (3). |
|
|
|
Operate both HANDLES (1) to flush water |
|
|
|
lines thoroughly. |
|
|
|
Replace AERATOR (3). | 1 |
|
|
3
4
11 CHECK DRAIN CONNECTIONS
Operate
Release 
Tighten
if necessary.
WASTE OUTLET
2
COLD
HOT
“P” TRAP
2
12 CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.
13 SERVICE
|
|
| HANDLE |
To change direction of handle rotation, |
|
| ASSEMBLY |
|
|
| |
proceed as follows: | UNTHREAD |
|
|
Turn valve to OFF position. Unthread HANDLE |
|
| |
|
|
| |
BASE (1) from DECK ADAPTER (2). | 1 |
|
|
Pull HANDLE ASSEMBLY off VALVE STEM (3). |
|
| |
Remove SPRING CLIP (4). Lift STOP WASHER (5), |
|
| |
turn 90˚ and replace. Replace SPRING CLIP (4). |
|
|
|
Find correct position of HANDLE ASSEMBLY by adjusting | 90˚ |
| |
male teeth on VALVE STEM (3) to female teeth in HANDLE. | 3 | ||
Thread HANDLE ASSEMBLY onto DECK ADAPTER (2) |
| 5 | |
until snug against mounting surface. | 4 |
| |
|
|
| |
If spout drips, operate handles several times from | 2 |
|
|
OFF to ON position. Do not force - handles turn |
|
|
|
only 90˚. | M968672 Rev . 1 . 1 |
|
4
